Kyocera VLSG-01 Summary, Vanlink Equipment Components, Required Hardware, Software Requirements

Page 5

VANLINK SYSTEM GUIDE

INTRODUCTION

This Installation Guide is intended for use with the VanLink System featuring TouchStar™ Technology designed and fabricated by Troll Systems Corporation. The sections and appendices that make up this manual are as follows:

Safety Considerations

Section 1 - Vanlink System Overview

Section 2 - VanLink System Requirements

Section 3 - Engineering Drawings

This guide or manual is based on the latest information available at the time of publication.

SUMMARY

VanLink is a system composed of several Troll Systems components that are coordinated work in a synchronous manner using proprietary software. This complex and innovative system configuration enables complete studio control of a broadcast news van while it is in the field.

VANLINK EQUIPMENT COMPONENTS

Required Hardware

The VanLink system is comprised of the following hardware components:

V750 - Troll Systems Remote VanLink controller

GPS/IMU – Troll Systems GPS & Magnetometer assembly

Quickset Pan/Tilt – Pan/Tilt pedestal w/ Azimuth and Elevation feedback

Pan/Tilt controller – Pan/tilt controller with remote interface capability

EVDO or 3G Router

Software Requirements

TouchStar 2008 – Windows application providing the control interface for VanLink.

TouchStar 02 Mapping Software – Displays and provides control for all receive sites including each vehicle equipped with VanLink.

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08

Introduction P-1

Image 5
Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Vanlink Equipment Components SummaryRequired Hardware Software RequirementsTerm Definition ABBREVIATIONS, ACRONYMS, TermsABBREVIATIONS, ACRONYMS, Terms Packaging WarrantyVanLink Component Set-up and Operation Conventions Used in this DocumentHint This format is used for all hints HintsContact Information Introduction Hazard Advisory Placards/Signs General Safety PrecautionsDo Not Service or Adjust Alone Electrical Power/Shock Hazards VanLink Safety ConsiderationsLifting/Handling Hazards Be Familiar With Resuscitation TechniquesCoincidental Damage to Equipment in Cabinets Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page System Overview VanLink System ENG Vehicle ConfigurationVanLink IMU Configuration VanLink System FeaturesVanLink Remote Studio Configuration Remote Control from the Studio or Control CenterRequired System Components SpecificationsHardware Requirements Master Controller Software RequirementsIntroduction Safety RecommendationsPower Requirements Installation RequirementsRack Installation Cable RequirementsRunning Cables 3.2 V750 Cable and Connector RequirementsTypical Network Configuration Pan and Tilt Cabling and Connector RequirementsIP Connectivity Master Controllers and TNS Accessibility3.4 GPS/IMU Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration Typical Network Configuration for VanLink GPS/IMU Assembly1 GPS/IMU Mounting Considerations 5.1 GPS/IMU Mounting ConsiderationsVanLink GPS GPS/IMU AssemblyRemote and Local Control CalibrationMagnetometer Calibration Antenna CalibrationTransmitter Control / Available Options Operating RequirementsSection Engineering Drawings Page Page Page Page Page Page