Kyocera VLSG-01 manual Conventions Used in this Document, VanLink Component Set-up and Operation

Page 9

CONVENTIONS USED IN THIS DOCUMENT

CONVENTIONS USED IN THIS DOCUMENT

VanLink Component Set-up and Operation

The Troll Systems V750 Remote Site Controller and its innovative capabilities is the heart of the VanLink system. For comprehensive information for this complex and dynamic component, consult the Troll Systems manual for the S750 Remote Site Controller manual which is identical to the V750 in almost all respects and functions.

Text appearing on the bottom line of the front panel display (just above the function

keys) of the V750 Remote site controller (i.e., commands associated with function keys A, B, C, D, and E) appear in the font, Arial Rounded MT Bold

Text and terms that are emphasized to draw the reader’s attention (due to their significance within the text) appear in italics. See the example below.

WARNINGS, CAUTIONS, NOTES, AND HINTS

Warnings

Warnings are included to alert the user that possible hazards are associated with the processes/procedures described. These may cause death or injury in any form, if the instructions in the operational or procedural task are not followed precisely. Warnings describe the potential hazards and possible impact that could occur if the warnings are not observed.

WARNING: This format is used for general warnings.

WARNING: This format is used for electrical warnings.

WARNING: This format is used for mechanical warnings.

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/17/2008

Introduction P-5

Image 9
Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Vanlink Equipment Components SummaryRequired Hardware Software RequirementsTerm Definition ABBREVIATIONS, ACRONYMS, TermsABBREVIATIONS, ACRONYMS, Terms Packaging WarrantyVanLink Component Set-up and Operation Conventions Used in this DocumentHint This format is used for all hints HintsContact Information Introduction General Safety Precautions Do Not Service or Adjust AloneHazard Advisory Placards/Signs Electrical Power/Shock Hazards VanLink Safety ConsiderationsBe Familiar With Resuscitation Techniques Coincidental Damage to Equipment in CabinetsLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page System Overview VanLink System ENG Vehicle ConfigurationVanLink IMU Configuration VanLink System FeaturesVanLink Remote Studio Configuration Remote Control from the Studio or Control CenterRequired System Components SpecificationsHardware Requirements Master Controller Software RequirementsIntroduction Safety RecommendationsPower Requirements Installation RequirementsRack Installation Cable RequirementsRunning Cables 3.2 V750 Cable and Connector RequirementsTypical Network Configuration Pan and Tilt Cabling and Connector RequirementsIP Connectivity Master Controllers and TNS Accessibility3.4 GPS/IMU Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration Typical Network Configuration for VanLink GPS/IMU Assembly1 GPS/IMU Mounting Considerations 5.1 GPS/IMU Mounting ConsiderationsVanLink GPS GPS/IMU AssemblyRemote and Local Control CalibrationMagnetometer Calibration Antenna CalibrationTransmitter Control / Available Options Operating RequirementsSection Engineering Drawings Page Page Page Page Page Page