Kyocera VLSG-01 manual Introduction

Page 12

INTRODUCTION

NOTES

User Manual P-8

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation Document VLSG-01 - 10/17/2008

Image 12

Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Summary Vanlink Equipment ComponentsRequired Hardware Software RequirementsABBREVIATIONS, ACRONYMS, Terms Term DefinitionABBREVIATIONS, ACRONYMS, Terms Warranty PackagingConventions Used in this Document VanLink Component Set-up and OperationHints Hint This format is used for all hintsContact Information Introduction General Safety Precautions Do Not Service or Adjust AloneHazard Advisory Placards/Signs VanLink Safety Considerations Electrical Power/Shock HazardsBe Familiar With Resuscitation Techniques Coincidental Damage to Equipment in CabinetsLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page VanLink System ENG Vehicle Configuration System OverviewVanLink System Features VanLink IMU ConfigurationRemote Control from the Studio or Control Center VanLink Remote Studio ConfigurationSpecifications Required System ComponentsHardware Requirements Master Controller Software RequirementsSafety Recommendations IntroductionInstallation Requirements Power RequirementsRack Installation Cable Requirements3.2 V750 Cable and Connector Requirements Running CablesPan and Tilt Cabling and Connector Requirements Typical Network ConfigurationMaster Controllers and TNS Accessibility IP Connectivity3.4 GPS/IMU Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration GPS/IMU Assembly Typical Network Configuration for VanLink1 GPS/IMU Mounting Considerations 5.1 GPS/IMU Mounting ConsiderationsGPS/IMU Assembly VanLink GPSCalibration Remote and Local ControlMagnetometer Calibration Antenna CalibrationOperating Requirements Transmitter Control / Available OptionsSection Engineering Drawings Page Page Page Page Page Page