Kyocera VLSG-01 manual Remote Control from the Studio or Control Center

Page 21

SYSTEM OVERVIEW

1.1.1.1Remote Control from the Studio or Control Center

Comprehensive remote control of ancillary vehicle functions including pan and tilt, vehicle tracking and signal optimization. (see Figure 1–3).

Troll Systems MC17 Master Controller with GUI Page / Map

PC

Switcher / Router

WAN

Figure 1–3. VanLink Remote Studio Configuration

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08

VanLink System Overview 1-3

Image 21
Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Vanlink Equipment Components SummaryRequired Hardware Software RequirementsTerm Definition ABBREVIATIONS, ACRONYMS, TermsABBREVIATIONS, ACRONYMS, Terms Packaging WarrantyVanLink Component Set-up and Operation Conventions Used in this DocumentHint This format is used for all hints HintsContact Information Introduction General Safety Precautions Do Not Service or Adjust AloneHazard Advisory Placards/Signs Electrical Power/Shock Hazards VanLink Safety ConsiderationsBe Familiar With Resuscitation Techniques Coincidental Damage to Equipment in CabinetsLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page System Overview VanLink System ENG Vehicle ConfigurationVanLink IMU Configuration VanLink System FeaturesVanLink Remote Studio Configuration Remote Control from the Studio or Control CenterRequired System Components SpecificationsHardware Requirements Master Controller Software RequirementsIntroduction Safety RecommendationsPower Requirements Installation RequirementsRack Installation Cable RequirementsRunning Cables 3.2 V750 Cable and Connector RequirementsTypical Network Configuration Pan and Tilt Cabling and Connector RequirementsIP Connectivity Master Controllers and TNS Accessibility3.4 GPS/IMU Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration Typical Network Configuration for VanLink GPS/IMU Assembly1 GPS/IMU Mounting Considerations 5.1 GPS/IMU Mounting ConsiderationsVanLink GPS GPS/IMU AssemblyRemote and Local Control CalibrationMagnetometer Calibration Antenna CalibrationTransmitter Control / Available Options Operating RequirementsSection Engineering Drawings Page Page Page Page Page Page