Kyocera VLSG-01 manual Hints, Hint This format is used for all hints

Page 10

INTRODUCTION

WARNING: This format is used for warnings which include the risk of fire.

Cautions

Cautions are included to alert the user that damage to the equipment is possible if the instructions in the operational or procedural task are not followed precisely. Cautions describe the hazards and possible impact that could occur if the cautions are not observed.

CAUTION: This format is used for all cautions.

Notes

Notes are included to provide the user with supplemental information, which is helpful but does not necessarily belong in the core text. Many operational and procedural tasks are easier with the addition of notes.

NOTE: This format is used for all notes.

Hints

Hints are generally included to inform the user of special features and/or methods of performing various tasks. These are usually unique features/methods that provide streamlined use of the equipment and/or user interface.

Hint: This format is used for all hints.

User Manual P-6

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/17/2008

Image 10
Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Required Hardware SummaryVanlink Equipment Components Software RequirementsABBREVIATIONS, ACRONYMS, Terms Term DefinitionABBREVIATIONS, ACRONYMS, Terms Warranty PackagingConventions Used in this Document VanLink Component Set-up and OperationHints Hint This format is used for all hintsContact Information Introduction Do Not Service or Adjust Alone General Safety PrecautionsHazard Advisory Placards/Signs VanLink Safety Considerations Electrical Power/Shock HazardsCoincidental Damage to Equipment in Cabinets Be Familiar With Resuscitation TechniquesLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page VanLink System ENG Vehicle Configuration System OverviewVanLink System Features VanLink IMU ConfigurationRemote Control from the Studio or Control Center VanLink Remote Studio ConfigurationHardware Requirements SpecificationsRequired System Components Master Controller Software RequirementsSafety Recommendations IntroductionRack Installation Installation RequirementsPower Requirements Cable Requirements3.2 V750 Cable and Connector Requirements Running CablesPan and Tilt Cabling and Connector Requirements Typical Network Configuration3.4 GPS/IMU Connectivity Master Controllers and TNS AccessibilityIP Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration 1 GPS/IMU Mounting Considerations GPS/IMU AssemblyTypical Network Configuration for VanLink 5.1 GPS/IMU Mounting ConsiderationsGPS/IMU Assembly VanLink GPSMagnetometer Calibration CalibrationRemote and Local Control Antenna CalibrationOperating Requirements Transmitter Control / Available OptionsSection Engineering Drawings Page Page Page Page Page Page