Kyocera VLSG-01 manual Specifications, Required System Components, Hardware Requirements

Page 22

SPECIFICATIONS

1.2SPECIFICATIONS

1.2.1Required System Components

1.2.1.1Hardware Requirements

The VanLink system of comprised of the following hardware components:

V750 - Troll Systems VanLink controller

GPS/IMU – Troll Systems GPS & Magnetometer assembly

Quickset Pan/Tilt – Pan/Tilt pedestal w/ Azimuth and Elevation feedback*

115VDC

Pan/Tilt controller – Pan/tilt controller with remote interface capability

C90VS-DC115A

EVDO or 3G Router** – Cellular data service router which utilizes either a Static public IP address or Dynamic DNS***

Kyocera One

*Optional potentiometer kits are available for most units

**Requires additional EVDO/3G card with service activated

***May incur monthly charges for additional Dynamic DNS services

1.2.1.2Master Controller Software Requirements

The VanLink system of comprised of the following software components at the Master Controller:

TouchStar 2008 – Windows application that provides control interface for VanLink including any additional device control that has been implemented.

TouchStar 02 Mapping Software – Displays and provides control for all receive sites including each vehicle equipped with VanLink.

User Manual 1-4

VanLink System featuring TouchStar™ Technology - Troll Systems Corporation

Document VLSG-01 - 10/21/08

Image 22
Contents VanLink System Installation Guide Troll Systems Corporation Table of Contents C100 User Interface Required Hardware SummaryVanlink Equipment Components Software RequirementsABBREVIATIONS, ACRONYMS, Terms Term DefinitionABBREVIATIONS, ACRONYMS, Terms Warranty PackagingConventions Used in this Document VanLink Component Set-up and OperationHints Hint This format is used for all hintsContact Information Introduction Do Not Service or Adjust Alone General Safety PrecautionsHazard Advisory Placards/Signs VanLink Safety Considerations Electrical Power/Shock HazardsCoincidental Damage to Equipment in Cabinets Be Familiar With Resuscitation TechniquesLifting/Handling Hazards Electrostatic Discharge Sensitive Esds Components Safety Considerations S-5 Page VanLink System ENG Vehicle Configuration System OverviewVanLink System Features VanLink IMU ConfigurationRemote Control from the Studio or Control Center VanLink Remote Studio ConfigurationHardware Requirements SpecificationsRequired System Components Master Controller Software RequirementsSafety Recommendations IntroductionRack Installation Installation RequirementsPower Requirements Cable Requirements3.2 V750 Cable and Connector Requirements Running CablesPan and Tilt Cabling and Connector Requirements Typical Network Configuration3.4 GPS/IMU Connectivity Master Controllers and TNS AccessibilityIP Connectivity EVDO/3G Router ConnectivityTypical VanLink Network Configuration 1 GPS/IMU Mounting Considerations GPS/IMU AssemblyTypical Network Configuration for VanLink 5.1 GPS/IMU Mounting ConsiderationsGPS/IMU Assembly VanLink GPSMagnetometer Calibration CalibrationRemote and Local Control Antenna CalibrationOperating Requirements Transmitter Control / Available OptionsSection Engineering Drawings Page Page Page Page Page Page