Oki 1.2 manual New connection window will appear

Page 28

The procedure for activating the Maintenance Console Software for the VoIP-TA unit is described in step-by-step instructions starting with the software through to connection with the VoIP-TA unit’s functions.

•Click on Start on the task bar, bring the cursor pointer on Program, and then click on VoIP-TA console.

•The Initial window will appear.

•Click on Run (R)on the menu bar.

•When the pull-down menu appears, select Connect.

•The New connection window will appear.

•Select a connection mode.

LAN connection:

Remote connection via a LAN interface.

Specify the IP address of the VoIP-TA in the Host entry area.

Serial connection:

Local and direct connection via a RS232C interface.

Specify the COM port for the PC to be connected to the VoIP-TA. Start connection by clicking on the OK button.

20Setup

Image 28

Contents

Installation Guide VersionSafety Warning Page Contents Setup VoIP-TA setting Window Important Equipment InformationImportant Safety Instructions Important Safety Instructions Introduction Welcome to the world of Oki Internet telephony…Outline FeaturesVoIP-TA Front Panel LEDsConnectors Back PanelWhen using both IP and Pstn When using IP network onlyMode StatusII Installation ConnectionsAnalogue telephone or G3 facsimile equipment Analogue PstnPower source Personal computer PCDuring installation During useVia an IP Network III Placing CallsGeneral Operation Services Third party incoming call during another callEnd-to-end service using Dtmf signaling Call transfer during a telephone callPlacing Calls How to register the absent service Absent serviceHow to cancel the absent service Details of Services Using both a Pstn line and the IP networkLine selection Third party incoming call during another callFor Pstn line not receiving services using hookflash hooking Power failure switching Identification of incoming callSetting IP Address Using the IP network onlyTranslating IP Address for VoIP IV Setup Maintenance Console Software RequirementsInstalling the Maintenance Console Software Maintenance Console Software CompatibilityFunctions of the Maintenance Console Software Data Setup ProcedureMode Function Password, see Chapter V,Activating and Deactivating the Software’s Functions New connection window will appear Changing Modes and Setup Conditions Changing to the Setup modeChanging setup conditions Saving all setup conditions in a file Reading information From the file Basic settings for Pstn line Descriptions DefaultSelect outgoing destination below For Pstn lineDescription Default Select outgoing destinationSelect Use Pstn line, Use VoIP line or Unavailable to dial Neglect first1st Outgoing Neglect Digit Destination 1st digit Dailing IP address NumberNumber VoIP-TA operation Dialed Dialed, excluding the first digit and 901 connects the callDialed, excluding the first digit and 567 connects the call Dialed, excluding the first digit and 789 connects the callDetailed settings for Pstn line Network settings UDP port No Specifies the UDP port number for communication Network Address Translation NAT Global address spaceStatic IP Masquerade with port number translations Gatekeeper settings To select Unicast GRQ or Multicast GRQ whenDetailed Gatekeeper settings BRQ DRQ GRQAddress table Sorting the list using each row as a key Sort with keyAddress table display editing Setup Description DetailsButton see pages 42 Voice settings RTP/RTCPSetting ms Byte Voice codec setting and bandwidth usedVoice codec FAX setting TCP/UDPSlic setting Functions of the Maintenance Console Software MaintenanceVerifying the Software Version Information Checking the Operation Status of the VoIP-TA Display Displayed contents Description Explanation of the displayed informationUpdating Unit Programs Changing the password VI Troubleshooting Symptom Items to checkRemote mode Local modeUsage VII SpecificationsPort number Important Equipment Information Warranty Period Warranty and ServiceFollowing the warranty period Oki Service Offices London Office