Oki 1.2 manual Number VoIP-TA operation Dialed, This is the same as dialing

Page 36

When the gatekeeper is in use, the VoIP-TA operates in the following

manner.

Number	VoIP-TA operation
dialed

7897 selects a line, gatekeeper is referenced for the IP address with all numbers dialed and 789 connects the call.

9019 selects a line, gatekeeper is referenced for the IP address with the numbers dialed, excluding the first digit and 01 connects the call.

9901	9 selects a line, gatekeeper is referenced for the IP address with the numbers
	dialed, excluding the first digit and 901 connects the call.
#567	# selects a line, gatekeeper is referenced for the IP address with the numbers
	dialed, excluding the first digit and 567 connects the call.
#789	# selects a line, gatekeeper is referenced for the IP address with the numbers
	dialed, excluding the first digit and 789 connects the call.
	(	Note	This is the same as dialing 789.)
	In the example above, when #789 is dialed, it is the same as dialing
	789, which may lead to misdialing in some cases.
	In order to totally separate the PSTN and VoIP lines, set the outgoing
	line data in the following manner.

•Set # to Use VoIP line with Neglect first digit selected.

•Set 0 to Use PSTN line with Neglect first digit selected.

•Set 1 to Use PSTN line without Neglect first digit selected.

•Set all others to Unavailable to dial.

28Setup

Image 36

Contents

Installation Guide VersionSafety Warning Page Contents Setup VoIP-TA setting Window Important Equipment InformationImportant Safety Instructions Important Safety Instructions Introduction Welcome to the world of Oki Internet telephony…Features OutlineVoIP-TA Front Panel LEDsConnectors Back PanelWhen using both IP and Pstn When using IP network onlyMode StatusII Installation ConnectionsAnalogue telephone or G3 facsimile equipment Analogue PstnPower source Personal computer PCDuring installation During useIII Placing Calls Via an IP NetworkGeneral Operation Services Third party incoming call during another callEnd-to-end service using Dtmf signaling Call transfer during a telephone callPlacing Calls Absent service How to register the absent serviceHow to cancel the absent service Details of Services Using both a Pstn line and the IP networkLine selection Third party incoming call during another callFor Pstn line not receiving services using hookflash hooking Power failure switching Identification of incoming callUsing the IP network only Setting IP AddressTranslating IP Address for VoIP IV Setup Maintenance Console Software RequirementsInstalling the Maintenance Console Software Maintenance Console Software CompatibilityFunctions of the Maintenance Console Software Data Setup ProcedureMode Function Password, see Chapter V,Activating and Deactivating the Software’s Functions New connection window will appear Changing Modes and Setup Conditions Changing to the Setup modeChanging setup conditions Saving all setup conditions in a file Reading information From the file Basic settings for Pstn line Descriptions DefaultSelect outgoing destination below For Pstn lineDescription Default Select outgoing destinationSelect Use Pstn line, Use VoIP line or Unavailable to dial Neglect first1st Outgoing Neglect Digit Destination 1st digit Dailing IP address NumberNumber VoIP-TA operation Dialed Dialed, excluding the first digit and 901 connects the callDialed, excluding the first digit and 567 connects the call Dialed, excluding the first digit and 789 connects the callDetailed settings for Pstn line Network settings UDP port No Specifies the UDP port number for communication Network Address Translation NAT Global address spaceStatic IP Masquerade with port number translations Gatekeeper settings To select Unicast GRQ or Multicast GRQ whenDetailed Gatekeeper settings BRQ DRQ GRQSorting the list using each row as a key Sort with key Address tableAddress table display editing Setup Details DescriptionButton see pages 42 Voice settings RTP/RTCPVoice codec setting and bandwidth used Setting ms ByteVoice codec FAX setting TCP/UDPSlic setting Maintenance Functions of the Maintenance Console SoftwareVerifying the Software Version Information Checking the Operation Status of the VoIP-TA Display Displayed contents Description Explanation of the displayed informationUpdating Unit Programs Changing the password VI Troubleshooting Symptom Items to checkRemote mode Local modeVII Specifications UsagePort number Important Equipment Information Warranty and Service Warranty PeriodFollowing the warranty period Oki Service Offices London Office