Oki 1.2 manual

Page 3

© 1999-2000, Oki Electric Industry Co., Ltd. All rights reserved.

The VoIP-TA Internet Telephony Adapter and the Maintenance Console Software are products of Oki Electric Industry Co. Ltd.

The right to reproduce this manual and/or the Maintenance Console Software is restricted by the Copyright Act.

No part of this document may be copied, reproduced, stored on a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, in whole or in part, without the written permission of Oki Electric Industry Co. Ltd.

Information in this document is subject to change without notice.

The contents of this document and the Maintenance Console Software have been prepared with the utmost care. However, if you notice an irregularity, please contact an authorized sales agent.

Oki Electric Industry Co. Ltd., assumes no responsibility with regard to consequences resulting from the use of the Maintenance Console Software and/or the contents and interpretation of the information contained in this manual.

Ethernet is a registered trademark of Xerox Corporation.

MS-DOS and Windows are registered trademarks of Microsoft Corporation.

Other companies and product names mentioned in this manual my be the trademarks or the registered trademarks of their respective companies. Oki Electric Industry Co. Ltd., neither endorses or recommends third-party products mentioned herein nor assumes responsibility with regard to the use or performance of these products.

ii

Image 3

Contents

Version Installation GuideSafety Warning Page Contents Important Equipment Information Setup VoIP-TA setting WindowImportant Safety Instructions Important Safety Instructions Welcome to the world of Oki Internet telephony… IntroductionFeatures OutlineVoIP-TA LEDs Front PanelBack Panel ConnectorsStatus When using both IP and PstnWhen using IP network only ModeAnalogue Pstn II InstallationConnections Analogue telephone or G3 facsimile equipmentPersonal computer PC Power sourceDuring use During installationIII Placing Calls Via an IP NetworkGeneral Operation Third party incoming call during another call ServicesCall transfer during a telephone call End-to-end service using Dtmf signalingPlacing Calls Absent service How to register the absent serviceHow to cancel the absent service Third party incoming call during another call Details of ServicesUsing both a Pstn line and the IP network Line selectionFor Pstn line not receiving services using hookflash hooking Identification of incoming call Power failure switchingUsing the IP network only Setting IP AddressTranslating IP Address for VoIP Maintenance Console Software Compatibility IV SetupMaintenance Console Software Requirements Installing the Maintenance Console SoftwarePassword, see Chapter V, Functions of the Maintenance Console SoftwareData Setup Procedure Mode FunctionActivating and Deactivating the Software’s Functions New connection window will appear Changing to the Setup mode Changing Modes and Setup ConditionsChanging setup conditions Saving all setup conditions in a file Reading information From the file For Pstn line Basic settings for Pstn lineDescriptions Default Select outgoing destination belowNeglect first Description DefaultSelect outgoing destination Select Use Pstn line, Use VoIP line or Unavailable to dialDailing IP address Number 1st Outgoing Neglect Digit Destination 1st digitDialed, excluding the first digit and 789 connects the call Number VoIP-TA operation DialedDialed, excluding the first digit and 901 connects the call Dialed, excluding the first digit and 567 connects the callDetailed settings for Pstn line Network settings UDP port No Specifies the UDP port number for communication Global address space Network Address Translation NATStatic IP Masquerade with port number translations To select Unicast GRQ or Multicast GRQ when Gatekeeper settingsBRQ DRQ GRQ Detailed Gatekeeper settingsSorting the list using each row as a key Sort with key Address tableAddress table display editing Setup Details DescriptionButton see pages 42 RTP/RTCP Voice settingsVoice codec setting and bandwidth used Setting ms ByteVoice codec TCP/UDP FAX settingSlic setting Maintenance Functions of the Maintenance Console SoftwareVerifying the Software Version Information Checking the Operation Status of the VoIP-TA Explanation of the displayed information Display Displayed contents DescriptionUpdating Unit Programs Changing the password Local mode VI TroubleshootingSymptom Items to check Remote modeVII Specifications UsagePort number Important Equipment Information Warranty and Service Warranty PeriodFollowing the warranty period London Office Oki Service Offices