Oki 1.2 manual Detailed Gatekeeper settings, Brq Drq Grq

Page 43

Detailed

gatekeeper settings

Item	Description	Default
RAS	Used to specify the gatekeeper’s response time-out value	RRQ	5 sec.
message	for the messages. This setting does not have to be changed.	URQ	3 sec.
Time-out	When the network response is often delayed, select a longer	ARQ	3 sec.
	time interval.	BRQ	3 sec.
		DRQ	3 sec.
		GRQ	3 sec.
RAS	Specifies the number of tries the gatekeeper will attempt when	RRQ	2
message	the time-out occurs for a message response. This setting does	URQ	1
Retry times	not have to be changed. When the network response is often	ARQ	2
	delayed, select a longer time interval.	BRQ	2
		DRQ 2
		GRQ	2
Gatekeeper	When an identifier is specified, only the gatekeeper with the	Not
identifier	specified identifier will be used, when detected.	specified.
Get VoIP	Activate if the telephone number of VoIP-TA is to	OFF
tel. No. from	be obtained from the gatekeeper. This setting does not
gatekeeper	need to be changed.
IRQ	Monitors a gatekeeper by monitoring the IRQ from the	None
monitored	gatekeeper. This setting does not need to be changed.
Time-out	Used to specify the time-out value for monitoring IRQ.	1 min.

Default values, set at the time of product shipping, are displayed when the Restore default button is clicked.

Setup 35

Image 43

Contents

Version Installation GuideSafety Warning Page Contents Important Equipment Information Setup VoIP-TA setting WindowImportant Safety Instructions Important Safety Instructions Welcome to the world of Oki Internet telephony… IntroductionOutline FeaturesVoIP-TA LEDs Front PanelBack Panel ConnectorsStatus When using both IP and PstnWhen using IP network only ModeAnalogue Pstn II InstallationConnections Analogue telephone or G3 facsimile equipmentPersonal computer PC Power sourceDuring use During installationVia an IP Network III Placing CallsGeneral Operation Third party incoming call during another call ServicesCall transfer during a telephone call End-to-end service using Dtmf signalingPlacing Calls How to register the absent service Absent serviceHow to cancel the absent service Third party incoming call during another call Details of ServicesUsing both a Pstn line and the IP network Line selectionFor Pstn line not receiving services using hookflash hooking Identification of incoming call Power failure switchingSetting IP Address Using the IP network onlyTranslating IP Address for VoIP Maintenance Console Software Compatibility IV SetupMaintenance Console Software Requirements Installing the Maintenance Console SoftwarePassword, see Chapter V, Functions of the Maintenance Console SoftwareData Setup Procedure Mode FunctionActivating and Deactivating the Software’s Functions New connection window will appear Changing to the Setup mode Changing Modes and Setup ConditionsChanging setup conditions Saving all setup conditions in a file Reading information From the file For Pstn line Basic settings for Pstn lineDescriptions Default Select outgoing destination belowNeglect first Description DefaultSelect outgoing destination Select Use Pstn line, Use VoIP line or Unavailable to dialDailing IP address Number 1st Outgoing Neglect Digit Destination 1st digitDialed, excluding the first digit and 789 connects the call Number VoIP-TA operation DialedDialed, excluding the first digit and 901 connects the call Dialed, excluding the first digit and 567 connects the callDetailed settings for Pstn line Network settings UDP port No Specifies the UDP port number for communication Global address space Network Address Translation NATStatic IP Masquerade with port number translations To select Unicast GRQ or Multicast GRQ when Gatekeeper settingsBRQ DRQ GRQ Detailed Gatekeeper settingsAddress table Sorting the list using each row as a key Sort with keyAddress table display editing Setup Description DetailsButton see pages 42 RTP/RTCP Voice settingsSetting ms Byte Voice codec setting and bandwidth usedVoice codec TCP/UDP FAX settingSlic setting Functions of the Maintenance Console Software MaintenanceVerifying the Software Version Information Checking the Operation Status of the VoIP-TA Explanation of the displayed information Display Displayed contents DescriptionUpdating Unit Programs Changing the password Local mode VI TroubleshootingSymptom Items to check Remote modeUsage VII SpecificationsPort number Important Equipment Information Warranty Period Warranty and ServiceFollowing the warranty period London Office Oki Service Offices