Oki 1.2 manual Address table, Sorting the list using each row as a key Sort with key

Page 44

Address table

The address table is available only when the gatekeeper is NOT in use.

Outgoing destinations using the VoIP line are set in this table. The settings in this table is used to originate calls to the outgoing destinations.

Item	Description	Default
Address	Sets VoIP telephone numbers, IP addresses and up to 100	None
table	port numbers*.

Sorting the list using each row as a key (Sort with key)

The address table can be sorted by using a VoIP telephone number, IP address or port number as the key for sorting.

Address table display editing

Use the following methods to edit the contents of the address table. The changes are saved in the VoIP-TA by clicking on the OK or Save button.

36Setup

Image 44

Contents

Installation Guide VersionSafety Warning Page Contents Setup VoIP-TA setting Window Important Equipment InformationImportant Safety Instructions Important Safety Instructions Introduction Welcome to the world of Oki Internet telephony…VoIP-TA FeaturesOutline Front Panel LEDsConnectors Back PanelWhen using both IP and Pstn When using IP network onlyMode StatusII Installation ConnectionsAnalogue telephone or G3 facsimile equipment Analogue PstnPower source Personal computer PCDuring installation During useGeneral Operation III Placing CallsVia an IP Network Services Third party incoming call during another callEnd-to-end service using Dtmf signaling Call transfer during a telephone callPlacing Calls How to cancel the absent service Absent serviceHow to register the absent service Details of Services Using both a Pstn line and the IP networkLine selection Third party incoming call during another callFor Pstn line not receiving services using hookflash hooking Power failure switching Identification of incoming callTranslating IP Address for VoIP Using the IP network onlySetting IP Address IV Setup Maintenance Console Software RequirementsInstalling the Maintenance Console Software Maintenance Console Software CompatibilityFunctions of the Maintenance Console Software Data Setup ProcedureMode Function Password, see Chapter V,Activating and Deactivating the Software’s Functions New connection window will appear Changing Modes and Setup Conditions Changing to the Setup modeChanging setup conditions Saving all setup conditions in a file Reading information From the file Basic settings for Pstn line Descriptions DefaultSelect outgoing destination below For Pstn lineDescription Default Select outgoing destinationSelect Use Pstn line, Use VoIP line or Unavailable to dial Neglect first1st Outgoing Neglect Digit Destination 1st digit Dailing IP address NumberNumber VoIP-TA operation Dialed Dialed, excluding the first digit and 901 connects the callDialed, excluding the first digit and 567 connects the call Dialed, excluding the first digit and 789 connects the callDetailed settings for Pstn line Network settings UDP port No Specifies the UDP port number for communication Network Address Translation NAT Global address spaceStatic IP Masquerade with port number translations Gatekeeper settings To select Unicast GRQ or Multicast GRQ whenDetailed Gatekeeper settings BRQ DRQ GRQAddress table display editing Sorting the list using each row as a key Sort with keyAddress table Setup Button see pages 42 DetailsDescription Voice settings RTP/RTCPVoice codec Voice codec setting and bandwidth usedSetting ms Byte FAX setting TCP/UDPSlic setting Verifying the Software Version Information MaintenanceFunctions of the Maintenance Console Software Checking the Operation Status of the VoIP-TA Display Displayed contents Description Explanation of the displayed informationUpdating Unit Programs Changing the password VI Troubleshooting Symptom Items to checkRemote mode Local modePort number VII SpecificationsUsage Important Equipment Information Following the warranty period Warranty and ServiceWarranty Period Oki Service Offices London Office