Oki 1.2 manual Reading information From the file

Page 32

Reading information

from the file

•To read information contained in the saved file, click on the Read from file button in the setup window. The File selection window will be displayed.

•Select the appropriate

file, and click the Open button.

The Read-information select window will be displayed.

The default setting reads all the setup conditions within a file. This setting can be changed by activating or deactivating the Address table or Other set values as required.

•When the settings have been made, click the OK button.

24Setup

Image 32

Contents

Installation Guide VersionSafety Warning Page Contents Setup VoIP-TA setting Window Important Equipment InformationImportant Safety Instructions Important Safety Instructions Introduction Welcome to the world of Oki Internet telephony…VoIP-TA FeaturesOutline Front Panel LEDsConnectors Back PanelWhen using both IP and Pstn When using IP network onlyMode StatusII Installation ConnectionsAnalogue telephone or G3 facsimile equipment Analogue PstnPower source Personal computer PCDuring installation During useGeneral Operation III Placing CallsVia an IP Network Services Third party incoming call during another callEnd-to-end service using Dtmf signaling Call transfer during a telephone callPlacing Calls How to cancel the absent service Absent serviceHow to register the absent service Details of Services Using both a Pstn line and the IP networkLine selection Third party incoming call during another callFor Pstn line not receiving services using hookflash hooking Power failure switching Identification of incoming callTranslating IP Address for VoIP Using the IP network onlySetting IP Address IV Setup Maintenance Console Software RequirementsInstalling the Maintenance Console Software Maintenance Console Software CompatibilityFunctions of the Maintenance Console Software Data Setup ProcedureMode Function Password, see Chapter V,Activating and Deactivating the Software’s Functions New connection window will appear Changing Modes and Setup Conditions Changing to the Setup modeChanging setup conditions Saving all setup conditions in a file Reading information From the file Basic settings for Pstn line Descriptions DefaultSelect outgoing destination below For Pstn lineDescription Default Select outgoing destinationSelect Use Pstn line, Use VoIP line or Unavailable to dial Neglect first1st Outgoing Neglect Digit Destination 1st digit Dailing IP address NumberNumber VoIP-TA operation Dialed Dialed, excluding the first digit and 901 connects the callDialed, excluding the first digit and 567 connects the call Dialed, excluding the first digit and 789 connects the callDetailed settings for Pstn line Network settings UDP port No Specifies the UDP port number for communication Network Address Translation NAT Global address spaceStatic IP Masquerade with port number translations Gatekeeper settings To select Unicast GRQ or Multicast GRQ whenDetailed Gatekeeper settings BRQ DRQ GRQAddress table display editing Sorting the list using each row as a key Sort with keyAddress table Setup Button see pages 42 DetailsDescription Voice settings RTP/RTCPVoice codec Voice codec setting and bandwidth usedSetting ms Byte FAX setting TCP/UDPSlic setting Verifying the Software Version Information MaintenanceFunctions of the Maintenance Console Software Checking the Operation Status of the VoIP-TA Display Displayed contents Description Explanation of the displayed informationUpdating Unit Programs Changing the password VI Troubleshooting Symptom Items to checkRemote mode Local modePort number VII SpecificationsUsage Important Equipment Information Following the warranty period Warranty and ServiceWarranty Period Oki Service Offices London Office