F A X I N G U S I N G P R E S E T 2
Note: How to set presets is covered in chapter 4 of this guide, "Customizing your WorkCentre."
Faxing Using Preset 2
Your WorkCentre is set up with fax as a factory default setting for sending Faxes from your PC modem using the WorkCentre - QuickLink III PC Fax. This fax software uses the modem on your PC to send faxes.
You can scan a document for faxing using preset 2.
1 | Place your original | |||||||
glass or in the Set Document Feeder (M950 only). | ||||||||
2 | On the control panel, press the Scan Mode | |||||||
|
| button. |
|
|
|
|
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
| - | + |
|
3 | Press the right Navigator |
|
| button until | ||||
the display reads, "Scan using: Preset 2." | ||||||||
4 | Press the Select |
| button. A check mark | |||||
| ||||||||
appears next to preset 2 to show that it is selected. |
Press Start and follow the instructions on
5 the PC screen. The original scans and the WorkCentre - QuickLink III PC Fax application opens on your PC with your scanned original attached.
6.2