P72895_F1D104-OSD-univ_man.qxd 7/16/01 3:24 PM Page 14
Usage (continued)
SCAN TIME:
Amount of time the OmniView™ PRO stays on one port before switching to the next port when in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port Name remains displayed
SCAN TIME: |
|
| |
■ 7sec | ■ 15sec | ■ 30sec | ■ 60sec |
DISPLAY TIME: |
|
| |
■ 7sec | ■ 15sec | ■ 30sec | ■ 60sec |
|
|
|
|
[↕]: SELECT
(INS): RENAME
(Enter): COMPLETE
(Esc): Exit
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKs (if their slave units present) and then puts the unit in AutoScan mode. If the unit is a single MASTER unit, pressing the button immediately invokes AutoScan mode. This is evident by a long BEEP, followed by two short beeps.
14