3M 813 owner manual Defragmenting

		Troubleshooting
DEFRAGMENTING	The printer is defragmenting memory.	CAUTION Do NOT turn off the
(Printer stops.)		printer power during defragmenting.
		Doing so can damage the printer.
		Allow the printer to finish
		defragmenting. If you get this
		error message frequently, check your
		label formats. Formats that write to and
		erase memory frequently may cause
		the printer to defragment often. Using
		properly coded label formats usually
		minimizes the need for defragmenting.
		If this error message does not go
		away, contact 3M Service. The printer
		requires service.
OUT OF MEMORY	There is not enough memory to perform	Free up some of the printer’s memory
(function)	the function specified on the second	by adjusting the label format or printer
	line of the error message.	parameters. One way to free up
		memory is to adjust the print width to
		the actual width of the label instead
		of leaving the print width set to the
		default. See Zebra XiIIIPlus User
		Guide (PDF on drivers CD).
		Ensure that the device, such as flash
		memory or PCMCIA card, is installed
		and not write-protected or full.
		Ensure that the data is not directed
		to a device that is not installed or is
		unavailable.
		See Zebra XiIIIPlus User Guide (PDF
		on drivers CD) for more information
		about the specified function.

Copyright © 2009, 3M. All rights reserved. 41