4. GUI Installation and Operation
GUI Operation
Use the following steps to perform a sample sequence:
1.Two presets were configured and loaded earlier in this tutorial. Refer to the “Preset Save And Recall” section for details.
2.Be sure that the two "On" boxes for sequences 1 and 2 are checked.
3.Set the delay for 3 seconds duration for each sequence.
4.Click the Start key.
5.Click the Video Switching Tab and watch the input assignments change every 3 seconds. Look at the front panel, and note that the input assignment for output channel 1 is showing the same activity.
6.Click the Sequence Tab and stop the sequence.
MatrixPRO • 16x16 and 8x8 |
| 43 |
|