Fujitsu RX200 S5 manual Installing a Sata DVD drive

Page 38

Installing a SATA DVD drive

Accessible drive

7.1Installing a SATA DVD drive

ÊOpen the server as described in chapter “Preparation” on page 19.

ÊFirst remove the dummy module by pushing it forward out of the housing.

VCAUTION!

Keep the dummy module for future use. If you remove the accessible drive again and do not replace it with a new one, the dummy module must be reinstalled to comply with EMC regulations and to satisfy cooling requirements and fire protection measures.

Figure 16: Connecting the DVD cable

ÊConnect the free ends of the DVD cable to the corresponding connectors on the HDD backplane (see arrow) or on the system board ("SATA ODD", see also section “Cable diagrams” on page 68).

38

Options Guide

RX200 S5

Image 38

Contents

Primergy RX200 S5 Server Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOContents Contents Documentation overview PrefaceConcept and target groups Documentation overview Preface Further sources of informationExpansions and conversions Expansions and conversions Preface TPMNotational conventions Page Procedure Page Safety instructions Installation and operation Before starting upOptions Guide Batteries Never remove parts of the CD/DVD drive casing Working with CDs/DVDs and CD/DVD drivesLaser information Modules with electrostatic-sensitive components ESD labelPreparation Pulling out/removing the serverOpening the server Preparation Removing the housing coverOpening the server Removing the fan coverOpening the server Removing the air cowl Removing the air cowl PreparationInstalling a second processor ProcessorsInstalling a second processor Inserting the processorInstalling the heat sink ProcessorsReplacing the processor Replacing the processorReplacing the processor Replacing the processor Replacing the heat sink Page Main memory Equipping rules Independent Channel ModeMirrored Channel Mode Equipping rulesMain memory Performance Channel ModeSpare Channel Mode Extending/replacing the main memory Removing installed memory modules Extending/replacing the main memory Inserting memory modules Inserting a memory modulePage Accessible drive Installing a Sata DVD drive Installing a Sata DVD driveInstalling a Sata DVD drive Page HDD modules Removing an existing DVD drive or dummy module Removing the DVD drive or dummy moduleRemoving the DVD drive cage Demounting the DVD drive cageInstalling the backplane 8x HDD Removing the existing backplane 6x HDDInstalling the drive cage for 8x HDD Installing the HDD drive cageHDD #6 HDD #7 Inserting the HDD modulesInstalling an expansion card in riser cards Expansion cards and iBBURemoving the riser card holders Installing an expansion card in riser cardsInstalling an expansion card Riser card holder #2 with riser card Reinstalling the riser card holders Riser card holder equipped with a controllerInstalling the riser card holder Installing a modular RAID controllerInstalling a RAID controller Expansion cards and iBBUInstalling an iBBU Installing an iBBUInstalling an iBBU Installing the iBBU IBBU Routing the cable Connecting the cable to the modular RAID 5 controller USB solid state disk uSSD Position of the uSSD on the system boardPage Installing the TPM module Trusted Platform Module TPMPage Completion Fitting the air cowlDimm CPU #1 Fitting the air cowlFan #3/#4 Fan #1/#2 CompletionFan #11/#12 Closing the server Fit the fan cover see Removing the fan cover onPage Description From CablingCabling overview Cable diagrams Cable diagrams CablingCabling for up to 6 HDD modules Cabling for up to 8 HDD modules Index