vChange the request/response unit size to a lower value for the large transfer. This parameter setting optimizes response time at the expense of large transfer performance.
vReduce the pacing values for the large transfer to slow it down, which allows the interactive users more windows for getting on the line.
Note: The overall central processing unit time increases for the large transfer.
For more information about AS/400 communications, see the Communications Configuration book.
Performance considerations for AnyNet communications
AnyNet communications is a good performance factor for you to consider. It is more expensive to use than any of the OS/400 protocols because you spend twice as much to run two protocols.
To optimize AnyNet performance, consider the following:
vFor send and receive pairs, the most efficient use of an interface is with its own protocol stack. That is, intersystem communications function (ICF) and common programming interface communications (CPI Communications) perform the best with advanced
vEach communications interface performs differently depending on the scenario. ICF and CPI Communications perform the best with APPC.
Note: An alternative to AnyNet communications is to have SNA and TCP/IP running parallel or over the same lines in your network. Hence, performance implications can be surpassed by not using AnyNet.
For more information about AnyNet/400 sockets, see the book Sockets Programming .
Setting up the AnyNet environment
AnyNet/400 is an AnyNet family product. These products allow you to use application programs that are written for a certain communications protocol but also run over
To configure Transmission Control Protocol/Internet Protocol (TCP/IP) over advanced
1.Identify the set of IP addresses to route over the SNA network.
2.Tell the system how to convert the IP address to the SNA format.
For more information about APPC Over TCP/IP Configuration, see the APPC Programming book.
For more information about IPX Support, see the Internetwork Packet Exchange (IPX) Support.
For related information about AnyNet, see:
“AnyNet communications for the AS/400 system”
“Performance considerations for AnyNet communications”
AnyNet communications for the AS/400 system
AnyNet is an IBM implementation of the Multiprotocol Transport Networking (MPTN) architecture, such as AnyNet/2 and AnyNet/Multiple Virtual Storage (MVS). AnyNet capability allows applications and associated services that use application programming interfaces, such as sockets, intersystem communications function (ICF), or CPI Communications, the flexibility to use alternative network protocols, such as Systems Network Architecture (SNA) or TCP/IP. AnyNet is a family of products that allow applications that