IBM manual Connecting one AS/400 to another AS/400 system

	AS/400	Remote AS/400
AS/400 Prompt	Parameter	Parameter		Notes
	LCLLOCNAME	RMTLOCNAME	For systems not using APPN (APPN(*NO) specified for
			the controller and device descriptions), this value must
			match the value specified by the RMTLOCNAME
			parameter on the remote system device description.
			APPC device descriptions are automatically created as
			needed by the AS/400 APPN support, when the
			following is specified on the controller description:
			v	APPN(*YES)
			v	AUTOCRTDEV(*ALL)
Location Password	LOCPWD	LOCPWD	This parameter must match on both the local and
			remote APPC device.
			Note: If you want a value other than *NONE for APPN
			devices, this value must be configured on the
			QAPPNRMT configuration list.
Mode	MODE	MODE	For systems not using APPN (APPN(*NO) specified for
			the controller and device descriptions), this value must
			match the value specified by the MODE parameter on
			the remote device description.
			For systems using APPN (APPN(*YES) specified for the
			controller and device descriptions), the specified mode
			description must exist on the remote system. The mode
			description name need not be specified in the remote
			device description.
Remote location name	RMTLOCNAME	LCLLOCNAME	For systems not using APPN (APPN(*NO) specified for
			the controller and device descriptions), this value must
			match the value specified by the LCLLOCNAME
			parameter on the remote device description.
			APPC device descriptions are automatically created as
			needed by AS/400 APPN support if APPN(*YES) is
			specified for the controller description.
	RMTNETID	LCLNETID	RMTNETID specified on the local AS/400 system device
			description must match the local network ID specified in
			the network attributes of the remote AS/400 system.
Single session	SNGSSN	SNGSSN	For Element 1 ( single-session device description), this
			parameter must match on both the local and remote
			APPC device.
			Note: If you want a value other than *NO for APPN
			devices, this value must be configured on the
			QAPPNRMT configuration list.For Element 2 (number of
			single-session conversations), this parameter does not
			need to match the remote device.

For more information on AS/400 parameters, see the Communications Configuration book.

Connecting one AS/400 to another AS/400 system

Configuration parameters must be coordinated when you specify controller, device, and line descriptions for the local and remote AS/400.

Example 1: AS/400 to AS/400 using X.25

Chapter 6. Communicating with a remote AS/400 system 37