|
| 3174 |
|
AS/400 | AS/400 | Configuration |
|
Prompt | Parameter | Questions | Notes |
|
|
|
|
Local network | NETADR | 423 | Host DTE Address (HNAD) |
address |
|
| For X.25 SVCs, the network address specified on the |
|
|
| |
|
|
| CRTLINX25 command and in question 423 must match. |
|
|
|
|
NRZI data | NRZI | 313 | NRZ or NRZI Encoding |
encoding |
|
| For SDLC lines only, the values specified on the |
|
|
| |
|
|
| CRTLINSDLC command and in question 313 must match as |
|
|
| follows: |
|
|
| v If NRZI(*NO), 313 = 0 |
|
|
| v If NRZI(*YES), 313 = 1 |
Source service | SSAP | 940 | Ring Address Assignment |
access point |
|
| The value specified for the SSAP parameter on the |
|
|
| |
|
|
| CRTCTLRWS command must match the SAP@ associated |
|
|
| with the Ring@ (adapter address) of the AS/400 system on |
|
|
| the Ring Address Assignment display. Used for |
|
|
| only. |
|
|
|
|
SHM | 367 | X.21 Switched | |
mode |
|
| Values specified on the CRTCTLRWS command and in |
|
|
| |
|
|
| question 367 match as follows: |
|
|
| v If SHM(*NO), 367 = 0 |
|
|
| v If SHM(*YES), 367 = 2 |
Station address | STNADR | 104 | Control Unit Address |
|
|
| Value specified for question 104 must match the STNADR |
|
|
| specified on the CRTCTLRWS command. |
|
|
|
|
Switched | SWITCHED | 317 | Telecommunication Facilities |
connection |
|
| Values specified on the CRTLINSDLC command and in |
|
|
| |
|
|
| question 317 match as follows: |
|
|
| v If SWITCHED(*NO), 317 = 0 |
|
|
| v If SWITCHED(*YES), 317 = 1 |
Note: If you are using a 3174 Model 1L Gateway to connect an AS/400 system to a host system on a
Matching AS/400 parameters for a 3274 controller
You match the AS/400 configuration parameters with the configuration questions and sequence numbers to configure the 3274 controller. These parameters are described in the following table.
For more information about configuring the 3274 controller, see the 3274 Control Unit Planning, Setup, and Customizing Guide.
To configure the AS/400 to a 3274 controller:
vSee “Example: Connecting an AS/400 to a 3174 control unit” on page 61 for an example of connecting an AS/400 to a 3174 retail controller.
vUse the following table to connect an AS/400 to a 3274 controller.