IBM manual 3174 AS/400 Configuration Prompt Parameter Questions

		3174
AS/400	AS/400	Configuration
Prompt	Parameter	Questions	Notes
Local adapter	ADPTADR	107	Token-Ring Network Address of the Gateway
address			If the AS/400 system uses a Token-Ring network line to
			connect to the 3174 controller, values specified for question
			107 and for the ADPTADR parameter on the CRTLINTRN
			command must match.
			If the AS/400 system uses an Ethernet line through an 8209
			LAN Bridge, see ″Appendix C: Local Area Network
			Addressing Considerations″ in the Communications
			Configuration book, for information about specifying the
			ADPTADR parameter on the CRTLINETH command.
Connection	CNNNBR	423	Host DTE Address (HNAD)
number			For X.25 lines, the numbers specified on the CRTLINX25
			command and in question 423 must match.
		368	X.21 Switched Short-Hold Mode Dial Number
			For X.21 short-hold mode connections, the numbers
			specified on the CRTCTLRWS command and in question
			368 must match.
		424	3174 DTE Address
			For X.25 SVCs, the connection number specified on the
			CRTCTLRWS command and in question 424 must match.
Destination	DSAP	940	Ring Address Assignment
service access			The value specified for the DSAP parameter on the
point
			CRTCTLRWS command must match the SAP@ specified for
			the 3174 on the Ring Address Assignment display. Used for
			token-ring only.
Exchange	EXCHID	215	Physical Unit Identification
identifier			For switched connections, the 5-digit hexadecimal value
			specified for question 215 must match the last 5 digits of the
			exchange identifier specified on the CRTCTLRWS
			command.
Link type	LINKTYPE	101	Host Attachment (3174)
			Values specified on the CRTCTLRWS command and for
			question 101 must match as follows:
			v LINKTYPE(*SDLC), 101 = 2
			v LINKTYPE(*X25), 101 = 3
			v LINKTYPE(*LAN), 101 = 7 (token ring)
			v LINKTYPE(*LAN), 101 = 8 (Ethernet)
Modem data	MODEMRATE	318	Full- or Half-Speed Transmission
rate select			The values specified for the MODEMRATE parameter on the
			CRTLINSDLC and CRTLINX25 commands must match
			question 318 as follows:
			v If MODEMRATE(*FULL), 318 = 0
			v If MODEMRATE(*HALF), 318 = 1

Chapter 7. Communicating with remote workstation controllers 59