IBM Matching AS/400 parameters for 4684 retail controllers, Local node Hex, Remote node Hex

AS/400 Prompt	AS/400 Parameter	4680 Link Parameter
Local location	LOCADR	4680 SESSION ADDRESS parameter must match the LOCADR
address		parameter specified on the AS/400 CRTDEVRTL command. Session
		address 01 is reserved for host command processor sessions.
SSCP identifier	SSCPID	4680 SSCP ID parameter must match the SSCPID parameter specified on
		the AS/400 CRTCTLRTL command.

Matching AS/400 parameters for 4684 retail controllers

You must coordinate parameter values with the AS/400 and the 4684 retail controller when running IBM Retail Industry Programming Support Services (RIPSS). The following table lists those parameters.

AS/400 parameters are listed in alphabetical order; the commands on which the parameters are specified are included in the rightmost column of the table.

For more information about configuring for RIPSS on the 4684, see the IBM Retail Industry Programming Support Services: Planning and Installation Guide, SC33-0650.

To configure the AS/400 to a 4684 controller:

vSee “Examples: Connecting AS/400 to a 4690 retail controller” on page 75 for an example of an AS/400 connecting to a 4690 retail controller.

vUse the following table to connect to a 4690 retail controller.

	AS/400	RIPSS Configuration
AS/400 Prompt	Parameter	Display	RIPSS Prompt
LAN remote	ADPTADR	TRDLC Server Data	Local node (Hex)
adapter address			For Token-Ring connections, the values specified
			for the RIPSS configuration and for the AS/400
			CRTCTLRTL command must match.
Local adapter	ADPTADR	TRDLC Server Data	Remote node (Hex)
address			For Token-Ring connections, the values specified
			for the RIPSS configuration and for the AS/400
			CRTLINTRN command must match.
Destination service	DSAP	TRDLC Server Data	Local SAP (Hex)
access point			For Token-Ring connections, the values specified
			for the RIPSS configuration and for the AS/400
			CRTCTLRTL command must match.
Duplex	DUPLEX	SDLC Server Data	4-wire constant RTS?
			For SDLC connections, the values specified for
			RIPSS and AS/400 configurations must match:
			v If the RIPSS response is N, DUPLEX(*HALF)
			must be specified for the CRTLINSDLC
			command.
			v If the RIPSS response is Y, DUPLEX(YES) must
			be specified for the CRTLINSDLC command.

74Version 5