Cisco Systems IE200016TCB, IE20004TSB, IE20004TSL manual Accessing the CLI Through the Console Port

A P P E N D I X C

Configuring the Switch with the CLI-Based Setup Program

This appendix provides a command-line interface (CLI)-based setup procedure for a switch. For information about setting up the switch by using Express Setup, see the Cisco IE 2000 Switch Getting Started Guide.

Before connecting the switch to a power source, review the safety warnings in Warnings, page 2-1

For installation procedures, see Chapter 2, “Switch Installation.”

Accessing the CLI Through the Console Port

You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access the CLI:

•RJ-45 Console Port

•USB Mini-Type B Console Port

Removing the USB Mini-Type B Console Port Cover

To remove the cover from the USB mini-type B console port:

Step 1 Use a Philips screwdriver to loosen the captive screw on the USB mini-type B console port cover. See See Figure C-1. Remove the screw and take off the cover.

Cisco IE 2000 Switch Hardware Installation Guide

OL-25818-04 C-1