Cisco Systems IE20004TSL, IE20004TSB, IE200016TCB manual Power Connectors, Glc-Lh-Sm

Chapter 1 Product Overview

Front Panel

Table 1-2 Supported SFP Models

Type of SFP Module	Model
Commercial SFPs	• GLC-SX-MM
32 to 158°F (0 to 70°C)	• GLC-LH-SM
	• GLC-BX-U with DOM support
	• GLC-BX-D with DOM support
	• CWDM-SFP with DOM support
	• DWDM-SFP with DOM support
Extended temperature SFPs	• SFP-GE-S with DOM support
23 to 185°F (–5 to 85°C)	• SFP-GE-L with DOM support
	• SFP-GE-Z with DOM support
	• GLC-SX-SMD
	• GLC-LH-SMD
	• GLC-EX-SMD

For the most up-to-date list of supported SFP models for Cisco Industrial Ethernet switches, see http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_ 6981.html#wp138176

For installation instructions, see your SFP module documentation and the “Installing and Removing SFP Modules” section on page 2-42.

For cable specifications, see the “SFP Module Cables” section on page B-4.

Power Connectors

You connect the DC power to the switch through the front panel connectors. The switch has a dual-feed DC power supply; two connectors provide primary and secondary DC power (DC-A and DC-B). The DC power connectors are near the top right of the front panel. See Figure 1-1. Each power connector has an LED status indicator.

The switch power connectors are attached to the switch chassis. Each power connector has screw terminals for terminating the DC power (see Figure 1-5). All connectors are attached to the switch front panel with the provided captive screws.

The power connector labeling is on the panel. The positive DC power connection is labeled “+”, and the return connection is labeled “–”.

	Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04		1-11