Appendix B Cable and Connectors
Cables and Adapters
Figure B-9
Switch
1 TP0+
2 TP0-
3 TP1+
6 TP1-
4 TP2+
5 TP2-
7 TP3+
8 TP3-
Four Twisted-Pair Crossover Cable Schematics for 1000BASE-T Ports
Switch
1 TP0+
2 TP0-
3 TP1+
6 TP1-
| 4 | TP2+ | |
| 5 | TP2- | |
| 7 | TP3+ | 65274 |
| 8 | TP3- |
| |
To identify a crossover cable, hold the cable ends side-by-side, with the tab at the back. The wire connected to pin 1 on the left end should be the same color as the wire connected to pin 3 on the right end. The wire connected to pin 2 on the left end should be the same color as the wire connected to pin 6 on the right end.
Figure B-10 Identifying a Crossover Cable
273807
Console Port Adapter Pinouts
The console port uses an 8-pin RJ-45 connector, which is described in Table B-3and Table B-4. If you did not order a console cable, you need to provide an RJ-45-to-DB-9 adapter cable to connect the switch console port to a PC console port. You need to provide an RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a terminal. You can order an adapter (part number ACS-DSBUASYN=). For console port and adapter pinout information, see Table B-3and Table B-4.
Cisco IE 2000 Switch Hardware Installation Guide