Cisco Systems IE200016TCB, IE20004TSB, IE20004TSL Verifying Switch Operation, Where to Go Next

Chapter 2 Switch Installation

Verifying Switch Operation

Figure 2-31 Connecting to a Dual-Purpose Port

331562

1

0.5-3.0A

16TC

2

1

LC connector (optical)

2

RJ-45 connector (copper)

Step 2 Connect the other end of the cable to the other device.

By default, the switch detects whether an RJ-45 connector or SFP module is connected to a dual-purpose port and configures the port accordingly. You can change this setting and configure the port to recognize only an RJ-45 connector or only an SFP module by using the media type interface configuration command. For more information, see the Cisco IE 2000 Switch Command Reference.

Verifying Switch Operation

Before installing the switch in its final location, power on the switch, and verify that the switch powers up in boot fast style. The boot fast sequence allows the switch to boot up in less than 60 seconds.

Where to Go Next

If the default configuration is satisfactory, the switch does not need further configuration. You can use any of these management options to change the default configuration:

•Start Device Manager, which is in the switch memory, to manage individual and standalone switches. This is an easy-to-use web interface that offers quick configuration and monitoring. You can access Device Manager from anywhere in your network through a web browser. For more information, see the Getting Started Guide and the Device Manager online help.

	Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04		2-47