Cisco Systems IE200016TCB, IE20004TSB, IE20004TSL manual Connecting to an Ethernet Port

Chapter 2 Switch Installation

Connecting Destination Ports

Figure 2-26 Connecting to an Ethernet Port

331558

0.5-3.0A

1

16TC

2

1

2

10/100 port

10/100 or 10/100/100 port (depending on model)

Step 2 Connect the other end of the cable to an RJ-45 connector on the other device. The port LED turns on when both the switch and the connected device have established a link.

The port LED is amber while Spanning Tree Protocol (STP) discovers the topology and searches for loops. This can take up to 30 seconds, and then the port LED turns green. If the port LED does not turn on:

•The device at the other end might not be turned on.

•There might be a cable problem or a problem with the adapter installed in the attached device. See Chapter 3, “Troubleshooting,” for solutions to cabling problems.

Step 3 Reconfigure and reboot the connected device if necessary.

Step 4 Repeat Steps 1 through 3 to connect each device.

	Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04		2-41