Cisco Systems IE200016TCB, IE20004TSB manual Grounding the Switch, Dimensions, Attachable?, Usage

Chapter 2 Switch Installation

Connecting to Power

	Table 2-1	Supported Power Supplies
	5.9 in H x 2.1 in. W x		5.9 in. H x 2.1 in. W x	5.8 in. H x 2 in. W x	5.8 in. H x 2 in. W x
Dimensions	4.9 in. D		4.9 in. D	4.4 in. D	4.4 in. D
Attachable?	Non-attachable		Non-attachable	Attachable unit	Attachable unit
	Designed for PoE1		Designed for PoE	Powers the switch.	Powers the switch.
	modules, can be used to		modules, can be used to	Cannot be used to	Cannot be used to
	power the switch.		power the switch.	power PoE modules,	power PoE modules,
Usage				which require 48V DC.	which require 48V DC.

1.The models that support PoE provide up to four ports of either PoE (15.4 W per port; IEEE 802.3af) or PoE+ (30 W per port; IEEE 802.3at), depending on the power source used. See Power Requirements, page A-2.

Installing the Power Converter on a DIN Rail, Wall, or Rack Adapter

You install the power converter on a DIN rail, wall, or rack as you would a switch module.

Warning This equipment is supplied as “open type” equipment. It must be mounted within an enclosure that is suitably designed for those specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from accessibility to live parts. The interior of the enclosure must be accessible only by the use of a tool.

The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards. Statement 1063

Caution To prevent the switch assemble from overheating, there must be a minimum of 3 inches (76.19 mm) between any other device and the top, bottom, or sides of the switch assembly.

Grounding the Switch

Make sure to follow any grounding requirements at your site.

Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Warning This equipment is intended to be grounded to comply with emission and immunity requirements. Ensure that the switch functional ground lug is connected to earth ground during normal use. Statement 1064

Caution To make sure that the equipment is reliably connected to earth ground, follow the grounding procedure instructions, and use a UL-listed ring terminal lug suitable for number 10-to-12 AWG wire, such as Hollingsworth part number R3456B or equivalent)

	Cisco IE 2000 Switch Hardware Installation Guide
2-14	OL-25818-04