Extron electronic DXP HDMI, 68-1370-50 REV. C Rear Panels and Connections, DXP DVI Pro Rear Panel

Rear Panels and Connections

Most of the connectors are on the rear panels of the DXP switchers. The following figures show the rear panels of the four DVI models and the four HDMI models.

NOTE: The illustrations below show DXP 88 DVI Pro and

DXP 88 HDMI models, with 8 input and 8 output connectors.

The rear panels of the other DXP models are identical to these models except for the number of inputs and outputs

(see "About the DXP DVI Pro and DXP HDMI Series Matrix

Switchers" in the "Introduction" section for the available matrix sizes).

1	2	3
		DVI PRO - HDCP COMPLIANT

1	2	DVI-D INPUTS 3	4	1	2	DVI-D OUTPUTS 3	4
5	6	7	8	5	6	7	8

LISTED

C US1T23I.T.E.

	Figure 3. DXP DVI Pro Rear Panel
1		2					3
					HDMI - HDCP COMPLIANT
1	2	HDMI INPUTS	3	4	1	2	HDMI OUTPUTS 3	4
5	6		7	8	5	6	7	8

LISTED

C US1T23I.T.E.

Figure 4. DXP HDMI Rear Panel

4
LAN	RESET
	LINK
	ACT
REMOTE	RS232/RS422
4
LAN	RESET
	LINK
	ACT
REMOTE	RS232/RS422

5

6

7

5

6

7

WARNING: Remove power from the system before making any connections.

CAUTION: Use electrostatic discharge precautions (be electrically grounded) when making connections. Electrostatic discharge (ESD) can damage equipment, although you may not feel, see, or hear it.

AAC power connector — Plug a standard IEC power cord into this connector to connect the switcher to a 100 VAC to 240 VAC, 50 or 60 Hz power source.

6DXP DVI Pro and DXP HDMI Series • Setup