Extron electronic DXP HDMI setup guide Front Panel Config Port, Remote RS232/RS422 Connector

GRemote RS232/RS422 connector — Connect an RS-232 capable host device such as a computer or a touch panel control to the switcher via this 9-pin D connector for serial RS-232 or RS-422 control.

REMOTE

1

5

6	RS232/RS422
9

Pin	RS-232	Function	RS-422	Function
1	—	Not used	—	Not used
2	Tx	Transmit data	Tx–	Transmit data (–)
3	Rx	Receive data	Rx–	Receive data (–)
4	—	Not used	—	Not used
5	Gnd	Signal ground	Gnd	Signal ground
6	—	Not used	—	Not used
7	—	Not used	Rx+	Receive data (+)
8	—	Not used	Tx+	Transmit data (+)
9	—	Not used	—	Not used

Figure 7. Remote RS232/RS422 Connector

In the "Remote Control" section, see “SIS Commands” for definitions of some of the SIS commands (serial commands to control the switcher via this connector) and "Installing and Starting the Matrix Switchers Control Program" for details on how to install and use the control software.

Front Panel Config Port

If desired, connect a control system or computer to the front panel RS-232 Config port. Protocol for the port is:

•• 9600 baud

•• 8 data bits

•• 1 stop bit

•• No parity

•• No flow control

RS-232 Configuration Port

	CONTROL				I/O
ENTER	PRESET	VIEW	ESC	VIDEO	AUDIO
CONFIG
				DXP SERIES
			DIGITAL MATRIX SWITCHER

Figure 8. Front Panel Config Port

10DXP DVI Pro and DXP HDMI Series • Setup