COutput connectors —
NOTE: The switchers do not alter the video signal in any way.
The signal that is output by the switcher is in the same format as the input signal.
•• DVI Pro series: Connect DVI output devices to these female
•• HDMI series: Connect HDMI output devices to these female
DEthernet port — If desired, connect the DXP switcher to a computer, a network WAN or LAN hub, or a control system via this
Ethernet connection indicators — The Link and Act LEDs indicate the status of the Ethernet connection.
•• Link: Indicates that the switcher is properly connected to an Ethernet LAN. This green LED should light steadily.
•• Act (Activity): Indicates transmission of data on the
Ethernet links use Category (CAT) 3, 5e, or 6 unshielded twisted pair (UTP) or shielded twisted pair (STP) cables, terminated with
NOTES: • Do not use standard telephone cables. Telephone
cables do not support Ethernet or Fast Ethernet.
• Do not stretch or bend the cables because this can cause transmission errors.
Pins:
1 2 3 4 5 6 7 8
Insert Twisted
Pair Wires
RJ-45
Crossover Cable
| End 1 | End 2 |
Pin | Wire Color | Wire Color |
|
| |
1 | ||
2 | Green | Orange |
3 | ||
4 | Blue | Blue |
5 | ||
6 | Orange | Green |
7
8Brown Brown
T568A T568B
Straight-through Cable
Pin | End 1 | End 2 |
Wire Color | Wire Color | |
|
|
|
1 | ||
2 | Orange | Orange |
3 | ||
4 | Blue | Blue |
5 | ||
6 | Green | Green |
7
8Brown Brown
T568B T568B
Connector
A cable that is wired as T568A at one end | A cable that is wired the same at both ends |
and T568B at the other (Tx and Rx pairs | is called a |
reversed) is a "crossover" cable. | no pin or pair assignments are swapped. |
Figure 6. RJ-45 Connector and Pinout Tables
8DXP DVI Pro and DXP HDMI Series • Setup