Extron electronic 68-1370-50 REV. C Input connectors, Installing the LockIt Lacing Bracket

BInput connectors —

•• DVI Pro series: Connect DVI-D source devices to these female 29-pin DVI-I input connectors. Only single-link DVI-D signals are supported.

•• HDMI series: Connect HDMI source devices to these female 19-pin type A HDMI input connectors.

LockIt™ cable lacing brackets, one for each HDMI input and output connector, are provided with the DXP HDMI. These brackets can be used to secure the HDMI cables to the DXP connectors to reduce stress on the HDMI connectors and prevent signal loss due to loose cable connections.

To securely fasten an HDMI cable to the DXP using LockIt brackets:

1.Plug the HDMI cable into the panel connection.

3		4
1	2	5

Figure 5. Installing the LockIt Lacing Bracket

2.Loosen the HDMI connection mounting screw from the panel enough to allow the LockIt lacing bracket to be placed over it. The screw does not have to be removed.

3.Place the LockIt lacing bracket on the screw and against the HDMI connector, then tighten the screw to secure the bracket.

CAUTION: Do not overtighten the HDMI connector mounting screw. The shield to which it fastens is very thin and can easily be stripped.

4.Loosely place the included tie wrap around the HDMI connector and the LockIt lacing bracket as shown.

5.While holding the connector securely against the lacing bracket, use pliers or similar tools to tighten the tie wrap, then remove any excess length.

DXP DVI Pro and DXP HDMI Series • Setup 7