Extron electronic 68-1370-50 REV. C, DXP HDMI setup guide Installing the Program

Installing and Starting the Matrix Switchers Control Program

Another way to operate the switcher is via the Matrix Switchers Control Program. This program is contained on the Extron Software Products DVD (included with the switcher). Run this program on a PC connected to either of the switcher serial ports or the Ethernet port. See "D Ethernet port", "G Remote RS232/RS422 connector," and "Front Panel Config Port" in the "Installation" section for connection information. The program must be installed on a computer; it cannot be run from the software disc.

NOTE: For details on operating the program, see the DXP DVI Pro and DXP HDMI User Guide, “Matrix Software” section, and to the control program help file.

Installing the Program

1.Insert the DVD into the drive. The disc should start automatically. The Extron software DVD window appears.

Figure 20. Software Button on the Software DVD Window

NOTE: If the DVD does not self-start, run Launch.exe from the disc.

2.Click the Software tab.

DXP DVI Pro and DXP HDMI Series • Remote Control 33