Extron electronic 42-122-xx manual Track, Cut aluminum base track, Measure and cut track

Page 11

Installation

Step 3: Track

3-1Measure and cut the track pieces to the desired length.

NIf the track is to be cut, the base track must be 10” (25.4 cm) longer than the cover track. This is the length of the connectivity box, which sits on the base track but not on the cover track (see figure below right).

The end ramps will add an additional 9.36”
(23.8 cm) to the total length of the installed track.
The track should run up to but not enter the hole in
the wall.	Cut aluminum base track
	Cut aluminum base track
		10.00"
		(25.4 cm)
		Connectivity (AAP) Box
			Rubber Strip
			Aluminum
		7'-2"	Cover Track
	End Ramp	(2.184 m)
	End Ramp
			Side Ramp
	9.36"
	(23.77 cm)
	8'-0"
	(2.438 m)

Measure and cut track

AVTrac • Installation

Image 11

Contents AVTrac Installation GuideSicherheitsanleitungen Deutsch PrecautionsSafety Instructions English Consignes de Sécurité FrançaisAVTrac Floor System IntroductionOverview Kit Contents Kit Contents In-Wall Cable Routing Considerations Before Getting StartedPlanning Floor ConsiderationsAVTrac maximum slope is Wheelchair AccessibilityRoom Considerations Before Getting Started, cont’d Tools and Equipment Required for InstallationCut prelaid carpet roll to expose concrete InstallationFloor Remove carpet tiles to expose concreteMark wall Cut cable access hole in wallWall Measure and cut track TrackCut aluminum base track Pre-drill holes to secure connectivity box Track, cont’dPre-drill holes in track and ramps Positions of mounting holesScrew side ramps to floor Mate side ramp to base trackDrill into concrete and screw down track Secure connectivity box to the floor Connectivity BoxConnect wires to AC receptacle Power ModuleConnect AC conduit to junction box Power Module cont’dAttach AC power module Connect double isolated cable to junction boxRun cable to AAPs Install AAPsAAPs Cut carpet Finishing UpEnsure cables lay flat Fit cover trackAttach carpet tile to track raceway Refit carpetUse template to cut base board Reattach base board to wall Finishing up cont’d AVTrac installedReference Material SpecificationsAVTrac 480R Cont’dConnectivity box USA Universal AC Compatibility GuidePassive AAPs Optional AccessoriesTrack Accessories Active AAPsReference Material Extron’s Warranty Before Getting Started Quick Installation Checklist