Extron electronic 42-122-xx manual Track, cont’d, Pre-drill holes in track and ramps

Page 12

Installation

Step 3: Track, cont’d

3-2Drill mounting holes in the shallow grooves of the base track and side ramps using a 1/4" or 6 mm bit for drilling metal (not supplied).

NMounting holes must be a maximum of 3' (91 cm) apart and one must be within 6" (15.2 cm) of each end of the track.

Shallow Groove in Base Track (pre-drill holes)

Shallow Groove in Side Ramp (pre-drill holes)

Side Ramp

Base Track

Pre-drill holes in track and ramps

To ensure that all components are securely attached to the floor, Extron recommends that the predrilled holes should closely follow the pattern shown in this figure.

Positions of mounting holes

3-3Remove the cover panel and end plates from the connectivity box.

Examine the bottom of the connectivity box: one end has two mounting holes (one in each corner), the other end has three mounting holes (one in each corner and one in the center). The end with three holes faces back toward the track.

Align the end of the box with two mounting holes with the end of the base track. Mark where the mounting holes in the bottom of the box lie over the base track.

Using a 1/4" or 6 mm bit for drilling metal (not supplied), drill at least three mounting holes in the base track to secure the connectivity box.

To fully assemble the track and attach it securely to the floor (as shown in the figure at right), follow the instructions on the next page.

The end of the

 

Connectivity Box

Cover

with three

End Plate

mounting holes

 

faces back

Mounting Holes

towards the track.

 

End Plate

Pre-drill holes to secure connectivity box

10AVTrac • Installation

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Installation Guide AVTracPrecautions Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen DeutschIntroduction OverviewAVTrac Floor System Kit Contents Kit Contents Before Getting Started PlanningFloor Considerations In-Wall Cable Routing ConsiderationsWheelchair Accessibility Room ConsiderationsAVTrac maximum slope is Tools and Equipment Required for Installation Before Getting Started, cont’dInstallation FloorRemove carpet tiles to expose concrete Cut prelaid carpet roll to expose concreteCut cable access hole in wall WallMark wall Track Cut aluminum base trackMeasure and cut track Track, cont’d Pre-drill holes in track and rampsPositions of mounting holes Pre-drill holes to secure connectivity boxMate side ramp to base track Drill into concrete and screw down trackScrew side ramps to floor Connectivity Box Secure connectivity box to the floorPower Module Connect wires to AC receptaclePower Module cont’d Attach AC power moduleConnect double isolated cable to junction box Connect AC conduit to junction boxInstall AAPs AAPsRun cable to AAPs Finishing Up Ensure cables lay flatFit cover track Cut carpetRefit carpet Use template to cut base board Reattach base board to wallAttach carpet tile to track raceway AVTrac installed Finishing up cont’dSpecifications Reference MaterialCont’d AVTrac 480RConnectivity box Universal AC Compatibility Guide USAOptional Accessories Track AccessoriesActive AAPs Passive AAPsReference Material Extron’s Warranty Quick Installation Checklist Before Getting Started
Top Page Image Contents