Extron electronic 42-122-xx manual Room Considerations, Wheelchair Accessibility

Page 7

Room Considerations

Determine the A/V requirements for the room. Extron provides a complete range of AAPs that can be purchased separately to provide fully customizable central connectivity.

Select the best configuration for existing furniture, equipment, cables and the AVTrac. It may help to mark the position of the track using a marker pen or tape.

The connectivity box must be positioned under a podium or table to avoid creating a tripping hazard. AVTrac can be cut or extended to meet the needs of the room. (For further details, see step 3-1on page 9.)

Optional track component extension kits are also available.

Cable Cubby		Cable Cubby
Cable Cubby
MediaLink Controller	AVTrac	MediaLink Controller

AVTrac

Conference Room

Classroom

Wheelchair Accessibility

The slope and rise of the side and end ramps are less than 1:12 (1 inch of rise for each 12 inches run, approximately 4.5°).

4.5°

The AVTrac maximum slope is 4.5°

AVTrac • Before Getting Started

Image 7

Contents AVTrac Installation GuideSicherheitsanleitungen Deutsch PrecautionsSafety Instructions English Consignes de Sécurité FrançaisOverview IntroductionAVTrac Floor System Kit Contents Kit Contents In-Wall Cable Routing Considerations Before Getting StartedPlanning Floor ConsiderationsRoom Considerations Wheelchair AccessibilityAVTrac maximum slope is Before Getting Started, cont’d Tools and Equipment Required for InstallationCut prelaid carpet roll to expose concrete InstallationFloor Remove carpet tiles to expose concreteWall Cut cable access hole in wallMark wall Cut aluminum base track TrackMeasure and cut track Pre-drill holes to secure connectivity box Track, cont’dPre-drill holes in track and ramps Positions of mounting holesDrill into concrete and screw down track Mate side ramp to base trackScrew side ramps to floor Secure connectivity box to the floor Connectivity BoxConnect wires to AC receptacle Power ModuleConnect AC conduit to junction box Power Module cont’dAttach AC power module Connect double isolated cable to junction boxAAPs Install AAPsRun cable to AAPs Cut carpet Finishing UpEnsure cables lay flat Fit cover trackUse template to cut base board Reattach base board to wall Refit carpetAttach carpet tile to track raceway Finishing up cont’d AVTrac installedReference Material SpecificationsAVTrac 480R Cont’dConnectivity box USA Universal AC Compatibility GuidePassive AAPs Optional AccessoriesTrack Accessories Active AAPsReference Material Extron’s Warranty Before Getting Started Quick Installation Checklist