Extron electronic 42-122-xx manual Kit Contents

Page 5

Kit Contents

Box 2

Check the contents of each box to ensure all items are present.

	Double-sided Tape (1 roll)	5/32" Masonry Bit (1) and
	Double-sided Tape (1 roll)	3/16" Masonry Screws (30)
		3/16" Masonry Screws (30)
		AC Power Module (1)
Installation Guide (1)
		Cover AAP Plate for
Connectivity Box (1)		AC Power Module (1)
Connectivity Box (1)
		Unwired
		AC Power Conduit (1)
End Ramps (2)

Checklist for contents of box 2

Connectivity box (1) with 6/32" nut (1) to secure AC power module 9.35" (23.7 cm) quarter-circle end ramps (2)

Cover AAP plate for AC power module (1)

Double-sided adhesive tape (1 roll of 15') for rubber inlay strip 3/16" masonry screws (30)

5/32" masonry drill bit (1) Installation guide (1)

AC Power Module and Cable:

24' (7.32 m) unwired oval flex power conduit (shown) ( CO models: Universal module)

24' (7.32 m) double insulated cable (ISO models: French, European, and Universal modules)

AVTrac • Kit Contents

Image 5

Contents AVTrac Installation GuideSafety Instructions English PrecautionsConsignes de Sécurité Français Sicherheitsanleitungen DeutschAVTrac Floor System IntroductionOverview Kit Contents Kit Contents Planning Before Getting StartedFloor Considerations In-Wall Cable Routing ConsiderationsAVTrac maximum slope is Wheelchair AccessibilityRoom Considerations Before Getting Started, cont’d Tools and Equipment Required for InstallationFloor InstallationRemove carpet tiles to expose concrete Cut prelaid carpet roll to expose concreteMark wall Cut cable access hole in wallWall Measure and cut track TrackCut aluminum base track Pre-drill holes in track and ramps Track, cont’dPositions of mounting holes Pre-drill holes to secure connectivity boxScrew side ramps to floor Mate side ramp to base trackDrill into concrete and screw down track Secure connectivity box to the floor Connectivity BoxConnect wires to AC receptacle Power ModuleAttach AC power module Power Module cont’dConnect double isolated cable to junction box Connect AC conduit to junction boxRun cable to AAPs Install AAPsAAPs Ensure cables lay flat Finishing UpFit cover track Cut carpetAttach carpet tile to track raceway Refit carpetUse template to cut base board Reattach base board to wall Finishing up cont’d AVTrac installedReference Material SpecificationsAVTrac 480R Cont’dConnectivity box USA Universal AC Compatibility GuideTrack Accessories Optional AccessoriesActive AAPs Passive AAPsReference Material Extron’s Warranty Before Getting Started Quick Installation Checklist