Extron electronic 42-122-xx manual Mate side ramp to base track, Screw side ramps to floor

Page 13

3-4Lay the base track on the floor in the prepared location.

Mate the tabs in the side ramps with the grooves in the base track, and place the end ramps in position at the end of the track furthest from the wall.

Tab on side ramp mates with groove in base track.

Side Ramp

Base Track

Mate side ramp to base track

3-5Using the provided 5/32" masonry bit, drill

1 1/2" (3.8 cm) deep pilot holes into the concrete through the predrilled mounting holes in the track and ramps.

Drill a 5/32” x 1 1/2” deep hole into concrete.

Supplied Masonry Screws

Drill into concrete and screw down track

3-6With the provided masonry screws, secure the track and ramps to the floor.

NDo not use the holes that were drilled to secure the connectivity box in step 3-3.

Screw side ramps to floor

AVTrac • Installation

11

Image 13
Contents AVTrac Installation GuideSafety Instructions English PrecautionsConsignes de Sécurité Français Sicherheitsanleitungen DeutschOverview IntroductionAVTrac Floor System Kit Contents Kit Contents Planning Before Getting StartedFloor Considerations In-Wall Cable Routing ConsiderationsRoom Considerations Wheelchair AccessibilityAVTrac maximum slope is Before Getting Started, cont’d Tools and Equipment Required for InstallationFloor InstallationRemove carpet tiles to expose concrete Cut prelaid carpet roll to expose concreteWall Cut cable access hole in wallMark wall Cut aluminum base track TrackMeasure and cut track Pre-drill holes in track and ramps Track, cont’dPositions of mounting holes Pre-drill holes to secure connectivity boxDrill into concrete and screw down track Mate side ramp to base trackScrew side ramps to floor Secure connectivity box to the floor Connectivity BoxConnect wires to AC receptacle Power ModuleAttach AC power module Power Module cont’dConnect double isolated cable to junction box Connect AC conduit to junction boxAAPs Install AAPsRun cable to AAPs Ensure cables lay flat Finishing UpFit cover track Cut carpetUse template to cut base board Reattach base board to wall Refit carpetAttach carpet tile to track raceway Finishing up cont’d AVTrac installedReference Material SpecificationsAVTrac 480R Cont’dConnectivity box USA Universal AC Compatibility GuideTrack Accessories Optional AccessoriesActive AAPs Passive AAPsReference Material Extron’s Warranty Before Getting Started Quick Installation Checklist