Extron electronic 42-122-xx manual Power Module cont’d, Attach AC power module

Page 16

Installation

Step 5: Power Module cont’d

 

 

5-2The AC power module must be positioned under the triple AAP socket that is closest to the track. Seat the power module on the stud in the connectivity box.

Slide the power module side tabs into the slots on the side of the connectivity box.

Secure the module to the stud on the connectivity box by hand tightening the provided 6/32" nut.

NThe illustration at right shows the Central European AC power module. Australian, French, and Universal models are also available.

AC Power

Tabs

 

Module

 

Studs

Slots

Attach AC power module

5-3Extron recommends the circuit be attached to a junction box that is directly wired to the main circuit. The AC power module does not have a fuse and is rated at 10 A, maximum.

Feed the fish tape from the junction box, through the wall cavity or raceway to the point where the AC conduit or double insulated cable from the AVTrac enters the wall or raceway.

Attach the end of the conduit or cable securely to the hook on the fish tape and rewind the tape, drawing

the cable behind it. If necessary, one person can feed Run AC conduit through wall cutout the conduit or cable into the wall or channel while a

second pulls the fish tape from the other end. Connect the wires as shown in the figures below:

To 10 Amp

Main Circuit To 10 Amp

Conduit

Main Circuit

 

Conduit

Junction Box

 

 

Junction Box

Blue/Black

 

(neutral)

Blue/Black

 

 

(neutral)

Brown/Red

Brown/Red

(live)

(live)

 

Green/Yellow

Green/Yellow

 

(ground)

 

 

(ground)

Cable

 

 

restraint

Double insulated

Cable/AC Conduit

 

 

AC cable

 

 

From AVTrac AC

Power Module

Connect double isolated cable to junction box

From AVTrac AC

Power Module

Connect AC conduit to junction box

14AVTrac • Installation

Image 16
Contents Installation Guide AVTracPrecautions Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen DeutschOverview IntroductionAVTrac Floor System Kit Contents Kit Contents Before Getting Started PlanningFloor Considerations In-Wall Cable Routing ConsiderationsRoom Considerations Wheelchair AccessibilityAVTrac maximum slope is Tools and Equipment Required for Installation Before Getting Started, cont’dInstallation FloorRemove carpet tiles to expose concrete Cut prelaid carpet roll to expose concreteWall Cut cable access hole in wallMark wall Cut aluminum base track TrackMeasure and cut track Track, cont’d Pre-drill holes in track and rampsPositions of mounting holes Pre-drill holes to secure connectivity boxDrill into concrete and screw down track Mate side ramp to base trackScrew side ramps to floor Connectivity Box Secure connectivity box to the floorPower Module Connect wires to AC receptaclePower Module cont’d Attach AC power moduleConnect double isolated cable to junction box Connect AC conduit to junction boxAAPs Install AAPsRun cable to AAPs Finishing Up Ensure cables lay flatFit cover track Cut carpetUse template to cut base board Reattach base board to wall Refit carpetAttach carpet tile to track raceway AVTrac installed Finishing up cont’dSpecifications Reference MaterialCont’d AVTrac 480RConnectivity box Universal AC Compatibility Guide USAOptional Accessories Track AccessoriesActive AAPs Passive AAPsReference Material Extron’s Warranty Quick Installation Checklist Before Getting Started