Extron electronic 42-122-xx Finishing Up, Ensure cables lay flat, Fit cover track, Cut carpet

Page 18

Installation

Step 7: Finishing Up

At this point, the track and connectivity box must be secured to the floor, the electrical power must be connected, and the AAP sockets must be populated.

To complete the installation of the AVTrac, follow these instructions:

7-1Lay the cables and power cords flat against the base track. If necessary, feed excess cable back into the wall.

Ensure cables lay flat

7-2Snap the cover track onto the base track.

Fit cover track

7-3Before cutting and gluing carpet, remove all dust and debris with a vacuum cleaner.

Cut the carpet or carpet tiles so that they run up to but do not cover the aluminum track (see the diagram below).

NCut the carpet to abut the edge of the cover track. Do not align the cuts to the edge of the ramps as this will leave a gap between the end of the carpet and the cover track.

Cut carpet

Carpet covers ramps but not track.

AVTrac • Installation

Image 18

Contents Installation Guide AVTracConsignes de Sécurité Français PrecautionsSafety Instructions English Sicherheitsanleitungen DeutschIntroduction OverviewAVTrac Floor System Kit Contents Kit Contents Floor Considerations Before Getting StartedPlanning In-Wall Cable Routing ConsiderationsWheelchair Accessibility Room ConsiderationsAVTrac maximum slope is Tools and Equipment Required for Installation Before Getting Started, cont’dRemove carpet tiles to expose concrete InstallationFloor Cut prelaid carpet roll to expose concreteCut cable access hole in wall WallMark wall Track Cut aluminum base trackMeasure and cut track Positions of mounting holes Track, cont’dPre-drill holes in track and ramps Pre-drill holes to secure connectivity boxMate side ramp to base track Drill into concrete and screw down trackScrew side ramps to floor Connectivity Box Secure connectivity box to the floorPower Module Connect wires to AC receptacleConnect double isolated cable to junction box Power Module cont’dAttach AC power module Connect AC conduit to junction boxInstall AAPs AAPsRun cable to AAPs Fit cover track Finishing UpEnsure cables lay flat Cut carpetRefit carpet Use template to cut base board Reattach base board to wallAttach carpet tile to track raceway AVTrac installed Finishing up cont’dSpecifications Reference MaterialCont’d AVTrac 480RConnectivity box Universal AC Compatibility Guide USAActive AAPs Optional AccessoriesTrack Accessories Passive AAPsReference Material Extron’s Warranty Quick Installation Checklist Before Getting Started