Extron electronic 42-122-xx manual Install AAPs, Run cable to AAPs

Installation

Step 6: AAPs

At this point, the track, ramps and connectivitly box must all be securely in place, and the AC power module must be attached to the connectivity box and connected to an AC junction box.

To attach the Architectural Adapter Plates (AAPs), follow these instructions:

6-1Select up to seven AAPs to fill the remaining spaces in the cover of the connectivity box.

In models without the AC power module, fill all ten spaces of AAPs.

AAP	AC Outlet
	Cover Plate
	Openings for
	AAPs
End Plate	Cover

NExtron AAPs must be purchased separately.

End Plate

Install AAPs

N To prevent bending of cables, place the
AAP with the greatest depth requirement
	2.88" (	7.	30 cm)
(including cables) in the AAP slot closest to
the center ridge of the connectivity box.

6-2Use fish tape to run the cables from the connectivity box through the wall or raceway to the appropriate appliances (as described in section 5-3).

Attach the cables to the AAPs as described in the installation guide for each AAP module and secure the AAP to the cover of the connectivity box, using the screws provided.

Test the power and signals to the AAPs.

Run cable to AAPs

6-3	Reattach the end plates and cover panel.					Cover
		P
		AA SI	80xi5
				RGB
	O	R		T
	UDIA	COMPUTE			SELEC
						SHIFTH
				INPUT

End Plate

2.50" (6.30 cm)

AAPs

End Plate

AVTrac • Installation 15