Extron electronic 42-122-xx manual Introduction, Overview, AVTrac Floor System

Page 3

Introduction

Overview

This manual describes the AVTrac® components and provides instructions for installation.

LAN

AC Junction Box

Speakers

Projector

Extron AVTrac®

AVTrac Floor System

Low-profile Raceway System

AVTrac is a low-profile raceway system designed to safely and discretely run power, data, and A/V cables from a wall to a table, podium, or other furniture. The raceway system mounts directly onto the concrete floor and underneath the carpet.

AAP Compatible Connectivity Box

The modular enclosure supports up to ten single- space Extron Architectural Adapter Plates (AAPs) with hundreds of connection options creating a fully customizable connectivity solution.

Models with the AC module accommodate up to seven single-space AAPs. (AAPs are sold separately.)

Wheelchair Accessible

The slope of the side and end ramps is less than 1:12 (1 inch of rise for each 12 inches run, approximately 4.8°).

Choice of Finishes

The AVTrac 480C accommodates commercial grade carpet inlay 1/4" to 5/16" (0.6 to 0.8 cm) thickness in the aluminum raceway cap.

The AVTrac 480R accommodates the included black Roppe rubber strip inlay as its top finish.

AVTrac • Introduction

1

Image 3

Contents AVTrac Installation GuideSicherheitsanleitungen Deutsch PrecautionsSafety Instructions English Consignes de Sécurité FrançaisIntroduction OverviewAVTrac Floor System Kit Contents Kit Contents In-Wall Cable Routing Considerations Before Getting StartedPlanning Floor ConsiderationsWheelchair Accessibility Room ConsiderationsAVTrac maximum slope is Before Getting Started, cont’d Tools and Equipment Required for InstallationCut prelaid carpet roll to expose concrete InstallationFloor Remove carpet tiles to expose concreteCut cable access hole in wall WallMark wall Track Cut aluminum base trackMeasure and cut track Pre-drill holes to secure connectivity box Track, cont’dPre-drill holes in track and ramps Positions of mounting holesMate side ramp to base track Drill into concrete and screw down trackScrew side ramps to floor Secure connectivity box to the floor Connectivity BoxConnect wires to AC receptacle Power ModuleConnect AC conduit to junction box Power Module cont’dAttach AC power module Connect double isolated cable to junction boxInstall AAPs AAPsRun cable to AAPs Cut carpet Finishing UpEnsure cables lay flat Fit cover trackRefit carpet Use template to cut base board Reattach base board to wallAttach carpet tile to track raceway Finishing up cont’d AVTrac installedReference Material SpecificationsAVTrac 480R Cont’dConnectivity box USA Universal AC Compatibility GuidePassive AAPs Optional AccessoriesTrack Accessories Active AAPsReference Material Extron’s Warranty Before Getting Started Quick Installation Checklist