Extron electronic 42-122-xx manual Before Getting Started, cont’d

Page 8

Before Getting Started, cont’d

Tools and Equipment Required for Installation

Almost everything you need to install your AVTrac system has been included. You will need some basic tools and materials depending on the facility and requirements.

You can visit www.extron.com for a full range of cables and components for populating the connectivity box.

NAll structural steps and electrical installation should be performed by qualified personnel in accordance with local and national building codes and/or local and national electrical codes.

Extron recommends the following equipment (not provided) to ensure the AVTrac is properly installed:

Tools:

Miter saw with blade for cutting metal

Handsaw for cutting drywall

Utility knives (box cutters)

Power drill

1/4" or 6 mm bit for drilling metal

Tin snips (metal shears)

Tools for terminating cables (if required)

Phillips head screw driver

Hex nut driver (1/4" and 5/16")

Equipment/other:

Tape measure

Marker pen

Level

Fish tape (used for pulling cables through cavity walls)

Cable ties

Vacuum cleaner

Carpet glue

Safety goggles

6AVTrac • Before Getting Started

Image 8

Contents Installation Guide AVTracPrecautions Safety Instructions EnglishConsignes de Sécurité Français Sicherheitsanleitungen DeutschAVTrac Floor System IntroductionOverview Kit Contents Kit Contents Before Getting Started PlanningFloor Considerations In-Wall Cable Routing ConsiderationsAVTrac maximum slope is Wheelchair AccessibilityRoom Considerations Tools and Equipment Required for Installation Before Getting Started, cont’dInstallation FloorRemove carpet tiles to expose concrete Cut prelaid carpet roll to expose concreteMark wall Cut cable access hole in wallWall Measure and cut track TrackCut aluminum base track Track, cont’d Pre-drill holes in track and rampsPositions of mounting holes Pre-drill holes to secure connectivity boxScrew side ramps to floor Mate side ramp to base trackDrill into concrete and screw down track Connectivity Box Secure connectivity box to the floorPower Module Connect wires to AC receptaclePower Module cont’d Attach AC power moduleConnect double isolated cable to junction box Connect AC conduit to junction boxRun cable to AAPs Install AAPsAAPs Finishing Up Ensure cables lay flatFit cover track Cut carpetAttach carpet tile to track raceway Refit carpetUse template to cut base board Reattach base board to wall AVTrac installed Finishing up cont’dSpecifications Reference MaterialCont’d AVTrac 480RConnectivity box Universal AC Compatibility Guide USAOptional Accessories Track AccessoriesActive AAPs Passive AAPsReference Material Extron’s Warranty Quick Installation Checklist Before Getting Started