FastStream SC 5700 Physical Attributes | ATTO Technology specification

1.3 FastStream SC 5700 Physical Attributes

The ATTO FastStream SC 5700 is a Fibre Channel to Fibre Channel storage appliance which can be seamlessly integrated into a new or an existing storage environment.

The ATTO FastStream SC 5700 is available in an industry-standard 1U form factor for easy integration into industry-standard racks.

For installation instructions, refer to Install the FastStream Storage Controller on page 9.

Dimensions

Width: 17 inches

Length: 8.94 inches

Height: 1.7 inches (1U)

Weight: approximately 8 pounds

Cooling and airflow

Fibre Channel ports

The four independent 4-Gigabit Fibre Channel ports connect the FastStream to either a Fibre Channel Fabric or Fibre Channel Arbitrated Loop using optical SFP connectors and multimode fiber optic cable. Make sure all cables are anchored securely at both ends with the proper connectors.

Ports 1 and 2 connect to the host computer; ports 3 and 4 connect to devices (see Exhibit 1.3-1).

Management ports

The 10/100 base T Ethernet port is accessible from the RJ45 connector and supports local diagnostics.

Operating Temperature: 0°-40° C external

Humidity: 10-90% non-condensing

Airflow: air enters through slots on the right of the rear panel and exits through slots on the left of the rear panel.

CAUTION

Do not block the enclosure’s vents. The

The RS-232 serial port provides support for remote monitoring and management using a DB9 connector. The baud rate is programmable and preset at the factory to 115200 bps.

Reset/restore factory default switch

	1	6
	RX 2
		7
	TX 3
		8
	4
		9
	GND 5

FastStream does not allow data transfer if overheating occurs.

Power

Input voltage: 100-240VAC, 1.7-.7A, 50-60 Hz

Battery-backed event log: A rechargeable Lithium ion battery cell holds the event log memory for up to 30 days. If the FastStream has been disconnected from power, recharging begins automatically when power is restored to the system. The battery is fully charged after 36 hours of continuous power application.

WARNING

Risk of explosion if battery is removed and/or replaced by an incorrect type. Dispose of used batteries in accordance with your local environmental regulations.

Explosionsgefahr, wenn die Batterie falsch entfernt und/oder ersetzt wird. Entsorgen Sie benutzte Batterien in Übereinstimmung mit Ihren lokalen Umweltschutzbestimmungen.

To reset the FastStream, briefly insert a tool in the hole in the back panel.

To restore factory defaults, insert the tool in the hole in the back panel for more than four seconds until the green Ready LED blinks.

LED indicators

The LED indicators can be viewed from the back or the front side of the FastStream. See Exhibit 1.3-2 and Exhibit 1.3-3.

LEDs on the connector side are:

A bicolor Ready/Fault LED lights green to indicate ready, lights yellow to show a faulted condition, and is off to indicate not ready.

Embedded in the Ethernet port connector: a lighted green LED shows a valid link; off indicates that no link is present. A separate blinking yellow LED indicates activity.

Fibre Channel port: A lighted green LED indicates link; off means no link. A separate green LED indicates activity if it is lit, no activity if it is off.

ATTO Technology Inc. FastStream SC Installation and Operation Manual