
6.5 Serial Port Configuration Commands
The serial port configuration may be customized by using the following commands:
SerialPortBaudRate
Sets the baud rate the Diamond Storage Array uses for its terminal interface. Choices are 2400, 9600, 19200, 38400, 57600, 115200.
Default: 115200
Set syntax: set SerialPortBaudRate [2400 9600 19200 38400 57600 115200]
Get syntax: get SerialPortBaudRate
SerialPortHandshake
Describes which handshaking method the Diamond Storage Array uses for its terminal interface (hardware, Xon/Xoff or none). Choices are hardware, Xon or none
Default: none
Set syntax: set SerialPortHandshake [hard Xon none] Requires a SaveConfiguration Restart command Get syntax: get SerialPortHandshake
SerialPortEcho
Controls whether the Diamond Storage Array echoes characters on its
Default: disabled
Set syntax: set SerialPortEcho [enabled disabled] Requires a SaveConfiguration Restart command Get syntax: get SerialPortEcho
SerialPortStopBits
Configures/reports the number of stop bits per character for the Diamond Storage Array RS
Default: 1
Set syntax: set SerialPortStopBits [1 2] Requires a SaveConfiguration Restart command Get syntax: get SerialPortStopBits
37
ATTO Technology Inc.