Paradyne GranDSLAM 4200 manual Cables Required, DSL Ports

1. Installation

Cables Required

Table 1-2shows all the cables that may be required for your installation.

Table 1-2. Cable Descriptions

Connector Name	Connector and Cable	For Connecting . . .
DSL PORTS 1–24	50-pin RJ21X Telco-type	Up to 24 DSL ports to Main
	straight connector and 50-wire	Distribution Frame, punchdown
	cable. Two cables required, one	block, or splitters.
POTS 1–24	for DSL and one for POTS (if	Up to 24 POTS splitter ports to
	used).
		Main Distribution Frame or
		punchdown block.
4201 T1 MODULE:		A downstream
100Ω	RJ48C	GranDSLAM 4200 to an
		upstream ATM network.
4202 E1 MODULE:		A downstream
TTX/RX 75Ω	TBNC	upstreamGranDSLAMATM4200network.to an
120Ω	RJ48C
4203 T1/E1 IMA	RJ48C	A downstream
MODULE		GranDSLAM 4200 to an
		Tupstream ATM network.
		A GranDSLAM 4200
		aggregation unit to a basic
		unit in a stack.
MGMT	8-position modular plug and	he GranDSLAM 4200 to a
	8-wire Category 5 or better	Network Management System
	unshielded twisted pair (UTP)	over a Local Area Network (LAN)
	cable.	employing 10BaseT or
		100BaseT.
CONSOLE	DB9 plug connector and	he GranDSLAM 4200 to one of
	shielded cable.	the following:
	The other connector	A terminal or a PC with a
	depends on the serial port on	terminal emulation program,
	your terminal or PC, but	Tor
	Tnormally is a DB9 socket.
	The other connector	A modem.
	depends on the serial port on
	your modem, but normally is
	a DB25 plug.
4210 ALARM	3-position terminal block and	The GranDSLAM 4200 to an
	3-wire shielded, twisted-pair	alarm system.
	cable.
4220/4230 ALARM	5-position terminal block and	The GranDSLAM 4200 to an
	5-wire shielded, twisted pair	alarm system.
	cable.
BITS (Building	Not applicable.	For future use.
Integrated Timing
Supply)

4200-A2-GN20-10 October 2002 1-3