4. Configuration
Turn-up Procedure for Inband Management
Procedure
To turn up the GranDSLAM 4200 using inband management:
1.Manual Mode: At the unit, configure the IP address, net mask, and
DHCP Mode: Set the ATM1 physical address using the
Later, when determining what IP address has been assigned via DHCP, look for the MAC address in the DHCP server table. The assigned address is normally the address of the Ethernet port with 0101 appended (the ATM physical address).
2.At the NOC, build a PVC through the network to the unit using VPI/VCI 0,32 and 1483 routed encapsulation. Then, configure routers, etc., as necessary to route data from the NOC to the GranDSLAM 4200.
3.Enable security for your GranDSLAM 4200 unit. Using the TL1 command
4.Change the time, if necessary. The Simple Network Time Protocol (SNTP), which maintains the unit’s clock, defaults to enabled. However, you can change the time offset from Coordinated Universal Time (UTC) using the TZOFFSET parameter of the
Turn-up Procedure for Out-of-Band Management
In
Procedure
To turn up the GranDSLAM 4200 using the Ethernet interface:
1.At the unit, enable the Ethernet port.
2.Manual Mode: Assign an IP address, netmask, and
DHCP Mode: Configure the DHCP server out of the Ethernet port.
3.Configure routers, etc., as necessary to route data from the NOC to the GranDSLAM 4200.
4.Reset the DHCP server and the SNTP since they default to managing from the ATM interface (inband management).
5.Enable security for your GranDSLAM 4200 unit. Using the TL1 command
October 2002 |