Polycom 6400-S manual To configure network settings

Page 30

User Guide V2IU 6400-S Converged Network Appliance

To configure network settings:

1.In the Network page, move to the Network Settings section.

2.Enter an IP address for the Default Gateway

This must be the next-hop-router connected to Port 1, the Subscriber side interface

3.Enter the Primary DNS Server.

4.Enter the Secondary DNS Server.

5.Press Submit.

4 - 6

Image 30
Contents User Guide V2IU 6400-S Converged Network Appliance Trademark Information Contents Configuring the Firewall Configuring Network SettingsConfiguring VoIP Administrative OptionsContents User Guide V2IU 6400-S Converged Network Appliance Introduction Introducing the V2IU 6400-S Converged Network ApplianceService Provider E-1NxT-1/E-1 Branch Office Features Physical Connections and SpecificationsManagement Features User Guide V2IU 6400-S Converged Network Appliance Installing the 6400-S Physical Installation1If AC power supplies are installed If DC power supplies are installed Power Supplies1 DC Power Supply Interface RequirementsAC Power Supply Interface Requirements DC Power Supply LED IndicatorsConfiguring the V2IU 6400-S Connecting to the 6400-SUser Guide V2IU 6400-S Converged Network Appliance Navigating through the configuration pages Logging in and out of the 6400-SGetting help Getting information about the networkRouting Information Getting information about the system System uptime Recent Call Log Configuring Network Settings Configuring subscriber interface settingsConfiguring provider interface settings Setting the Ethernet link rate Link speed and duplex with locally attached devices Configuring the Network Setting DescriptionTo configure network settings Configuring VoIP To configure VoIP ALG Configuring VoIP Field Description Currently registered Configuring VoIP subnet routing Deleting a VoIP subnet route Configuring VoIP survivability Configuring sofswitch survivabilitySoftswitch redundancy configuration Configuring Vrrp To configure Sofswitch Redundancy, enter the followingConfiguring VoIP User Guide V2IU 6400-S Converged Network Appliance Configuring the Firewall Configuring the firewall basic settingsTo configure basic settings Configuring advanced firewall settings Basic settings rulesAdvanced setting rules Enabling or disabling the firewallAdministrative Options Changing the administration passwordSpecifying user commands Managing SIP, Mgcp or H.323 clients Selecting a client Deleting clientsQuerying clients Adding clientsRebooting the system Using Network Test ToolsRestarting the network Running a ping test Running a traceroute testUpgrading the firmware Configuring a management interface Configuring the interfaceReconnecting the 6400-S Configuring the trusted management addresses Move the connection from Port 2 to PortSetting the Provider MTU size Enabling Snmp Field Description Disabling Snmp Enabling remote system loggingAddressport Setting the system date and time Disabling remote system loggingCreating a static route Deleting a static route User Guide V2IU 6400-S Converged Network Appliance Appendix Troubleshooting TipsTrouble accessing the Internet No dial tonePinging the softswitch Telephone doesnt register with the softswitchChecking the configurations on the ALG Checking the ALG registration codeImportant Safeguards Regulatory NoticesOther Rights and Limitations Regulatory Notices Warranty and Warranty Exclusions Regulatory Notices Miscellaneous Regulatory Notices User Guide V2IU 6400-S Converged Network Appliance Regulatory Notices User Guide V2IU 6400-S Converged Network Appliance Regulatory Notices Compliance and Compatibility1 Regulatory Notices