Polycom 6400-S manual Regulatory Notices

Page 79

Regulatory Notices

exceptions for this. Our decision will be guided by the two goals of preserving the free status of all derivatives of our free software and of promoting the sharing and reuse of software generally.

NO WARRANTY

11.BECAUSE THE PROGRAM IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE PROGRAM, TO THE EXTENT PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE PROGRAM "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE PROGRAM IS WITH YOU. SHOULD THE PROGRAM PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION.

12.IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY COPYRIGHT HOLDER, OR ANY OTHER PARTY WHO MAY MODIFY AND/OR REDISTRIBUTE THE PROGRAM AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OR INABILITY TO USE THE PROGRAM (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES OR A FAILURE OF THE PROGRAM TO OPERATE WITH ANY OTHER PROGRAMS), EVEN IF SUCH HOLDER OR OTHER PARTY HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

END OF TERMS AND CONDITIONS

Regulatory Notices - 11

Image 79
Contents User Guide V2IU 6400-S Converged Network Appliance Trademark Information Contents Administrative Options Configuring Network SettingsConfiguring VoIP Configuring the FirewallContents User Guide V2IU 6400-S Converged Network Appliance Introducing the V2IU 6400-S Converged Network Appliance IntroductionService Provider E-1NxT-1/E-1 Branch Office Physical Connections and Specifications FeaturesManagement Features User Guide V2IU 6400-S Converged Network Appliance Physical Installation1 Installing the 6400-SIf AC power supplies are installed If DC power supplies are installed DC Power Supply Interface Requirements Power Supplies1DC Power Supply LED Indicators AC Power Supply Interface RequirementsConnecting to the 6400-S Configuring the V2IU 6400-SUser Guide V2IU 6400-S Converged Network Appliance Logging in and out of the 6400-S Navigating through the configuration pagesGetting information about the network Getting helpRouting Information Getting information about the system System uptime Recent Call Log Configuring subscriber interface settings Configuring Network SettingsConfiguring provider interface settings Setting the Ethernet link rate Link speed and duplex with locally attached devices Setting Description Configuring the NetworkTo configure network settings Configuring VoIP To configure VoIP ALG Configuring VoIP Field Description Currently registered Configuring VoIP subnet routing Deleting a VoIP subnet route Configuring sofswitch survivability Configuring VoIP survivabilitySoftswitch redundancy configuration To configure Sofswitch Redundancy, enter the following Configuring VrrpConfiguring VoIP User Guide V2IU 6400-S Converged Network Appliance Configuring the firewall basic settings Configuring the FirewallTo configure basic settings Basic settings rules Configuring advanced firewall settingsEnabling or disabling the firewall Advanced setting rulesChanging the administration password Administrative OptionsSpecifying user commands Managing SIP, Mgcp or H.323 clients Deleting clients Selecting a clientAdding clients Querying clientsUsing Network Test Tools Rebooting the systemRestarting the network Running a traceroute test Running a ping testUpgrading the firmware Configuring the interface Configuring a management interfaceReconnecting the 6400-S Move the connection from Port 2 to Port Configuring the trusted management addressesSetting the Provider MTU size Enabling Snmp Field Description Enabling remote system logging Disabling SnmpAddressport Disabling remote system logging Setting the system date and timeCreating a static route Deleting a static route User Guide V2IU 6400-S Converged Network Appliance No dial tone Troubleshooting TipsTrouble accessing the Internet AppendixChecking the ALG registration code Telephone doesnt register with the softswitchChecking the configurations on the ALG Pinging the softswitchRegulatory Notices Important SafeguardsOther Rights and Limitations Regulatory Notices Warranty and Warranty Exclusions Regulatory Notices Miscellaneous Regulatory Notices User Guide V2IU 6400-S Converged Network Appliance Regulatory Notices User Guide V2IU 6400-S Converged Network Appliance Regulatory Notices Compliance and Compatibility1 Regulatory Notices