TP-Link TD-W8960N manual Panel Layout, Front Panel, Name Status Description

TD-W8960N Wireless N ADSL2+ Modem Router User Guide

1.3 Panel Layout

1.3.1 The Front Panel

The Router’s LEDs are located on the front panel.

Figure 1-1

The Router’s LEDs and the QSS button are located on the front panel (View from left to right).

Name	Status		Description
Power	On		Power is on
	Off	Power is off
	On		A successful PPP connection has been built
Internet	Flashing	Data is being transferred over the Internet
	Off		There is no successful PPP connection or the	Router
			works on Bridge mode
	On		The LINE port has connected to ISP’s network
ADSL
	Flashing		The LINE port is connecting to the ISP’s network
	Off	The LINE port is disconnected
	On		The Wireless function is enabled
WLAN	Flashing	Sending or receiving data over wireless network
	Off	The Wireless function is disabled
	On		There is a device linked to the corresponding port but there
			is no activity
LAN 1-4
	Flashing	There is an active device linked to the corresponding port
	Off	There is no device linked to the corresponding port
	On		A wireless device has been successfully added	to the
			network by QSS function
QSS	Flashing		A wireless device is connecting to the network by QSS
			function
	Off		The wireless device failed to be added to the network by
			QSS function. Or have no QSＳ connection

)Note:

After a device is successfully added to the network by QSS function, the QSS LED will keep on for about 2 minutes and then turn off.

4